Spark Plugs and Wires
1992 grand am se when it gets warm or hot it seems to chug and almost die when throttle is pressed whats wrong with it it's not ig module or coil housing i changed those what could it be spark plugs?
June 19, 2006 9:45PM
Assuming your car has approximately 110,000 miles.Have your fuel pump checked it could be week.If it's making more noise than normal it probaly is. New O.E.M. pump is around $300.
What is the median cost of houses in the Houston, Texas area?
Where is throttle position sensor located at on a ford escape 6-cylinder .?
Asked in Cars & Vehicles
Are the throttle switches fitted to the 2001 movano the same as the 2007 movano?
Where is the thermostat in a 2005 Chevy Suburban?
The thermostat is located in the thermostat housing, front of the engine on the passenger side. The easiest way to locate it is to follow the large hose coming off the bottom of the radiator on the passenger side, toward the engine. This hose connects to the thermostat housing. It is secured with 2 10mm bolts. If you remove the intake tube between the throttle body and air filter box, you have almost unrestricted access to the housing.
Asked in Yamaha Motorcycles
Is the Raptor 250 faster or almost as fast as the 350?
Asked in Suzuki Motorcycles
Your suzuki ozark 250 quadrunner cuts out almost full throttle why?
Where is the speed sensor on a Mazda protege?
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
What damage can happen if you drive with a bad throttle position sensor?
No its dangerous. the computer has no idea what the throttle (gas pedal) position is. I will give you some tips, they are cheap and on the outside of the throttle body however they have security screws which are almost always destroyed when removing. Your best bet is to get a throttle body with sensor attached from a wrcking yard and swapping out the whole thing OR having dealer do it screw almost always strip out when removing old tps then it gets fun. It cannot be on there loose.