The answer will cost you a commitment to post the next thing you can't find on here but figure out yourself. Stop reading if that is too much to ask. :) Pull the three screws from the door panel. Pull the door panel up and off. It has a couple of hooks at the bottom that will come out when you pull the whole thing up. Don't worry about pulling the wiring loose just pull a couple of the plastic retainers out so you have more room to work. Pull the sound insulation (starting at the bottom) loose about a foot up and tape it out of the way. Swing the door panel back toward the rear of the door and hook the top on the door lock. Remove two of the 5/16ths screws holding the motor on. One through a small hole, and the other through a triangle already cut in the door frame. The third is a trick to get to. You can use a small wrench from the bottom but I drilled a hole in the door frame so I could get a socket in. Reach in and pull the motor loose by shaking it. It is still attached by a rivet that you'll have to drill out but pull it loose so you know which rivet to drill. Good luck and don't forget your commitment.
Simply purchase the window motor first. Unbolt the other window motor that needs replacement then mount the new one into the correct position and bolt the place.
Difficult procedure. If it has been determined that the motor itself needs replacement, unless you are extremely agile and mechanically inclined, recommend you take it to the dealer/repair shop.
Unfortunately you can't just change the motor. You have to buy and replace the whole assembly including the window. Its a rip-off but the motor, ratchet, arms and window comes as one replacement assembly.
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
http://www.ford-forums.com/ford-ranger/11517-procedures-replacing-power-window-motor-ford-ranger.html Try this link.
Since the Freestar is just a Windstar with a different name, try the "Related Question" below for getting started with replacing the window motor.
You have to drill out the rivets. a replacement motor will come with bolts and nuts to go back together
The motor that runs the window is probably in need of replacement. You can also check the fuse to make sure that that is working.
It is most likely a broken window regulator or bad electric motor. Don't know about the cost of the motor but the regulator will run $40-$70 + labor to install.
can probably raise the window/regulator by hand if you can remove the window motor from the regulator
Either the fuse is blown or the wiper motor is bad.
Torques motor 4.0 ford ranger?
The curb weight of the 1985 Ford Ranger is about 2600 to about 3200 pounds depending on the motor size and the amenities. This vehicle would have the single cab rather than an extended cab.
On a 1998 Ford Ranger : Both the 4.0 liter and the 3.0 liter V6 engines are an ( Over Head Valve ) design
It could be either the 4.0 L - OHV - V6 , or the 3.0 L - V6 engine
The first Ford Ranger was introduced in North America in 1983, serving as a replacement for the previous Ford Courier, both manufactured by the Ford Motor Company.
how do you change motor mount on 2002 ford ranger
How to remove the window motor from the regulator
A electric motor that moves the (window) wiper to clean the window.
Remove the inside door panel of your 2002 Chevy Cavalier. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
Remove the inside door panel of your 1994 Chevrolet Corsica. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
Remove the inside door panel from your Mercedes-Benz. Remove the wiring harness from the window motor. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.
The Oldsmobile Cutlass Cierra window lift motor is located inside of the door. Each window is equipped with a window lift motor.
Begin by removing the inside door panel of your 2001 Mercury Villager. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.