Top Answer
User Avatar
Wiki User
Answered 2014-11-20 06:17:05

For the 1993 Toyota Tercel, the O2 sensor has three different wire colors. These colors are: black, blue, and white.

User Avatar

Your Answer

Related Questions

The 1993 Toyota coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

.043 is the correct gaping for the plugs in a 1993 Toyota tercel. This is taken rite from the Hayes repair manual

Where is the O2 sensor on 1993 Toyota Mr2

where do you find the filling plug for the gear oil on a 1993 Toyota tercel

Mounted on top and inside the fuel tank.

The main fuse box is next to the hood release handle on the driver side.

Use the Autozone online repair manual. This is the link I use to access the Toyota Tercel info for a 3E engine.

At the top end of the lower radiator hose within the water outlet. I hope this helps you. Rob

if the spark plugs are black because your car is running too rich. your plugs are fouled.

The Diagnostic port, looking from front of vehicle, is located on the drivers side rear corner of the engine compartment

A '93 Tercel will take very close to four quarts of oil. Now I am not 100% sure but i think that the tranny will hold close to four quarts of gear oil.

It is located under the hood on the drivers side firewall between the power brake booster and the carbon canister.

in the catylitic converter (underneath car...connected to your exhaust

2 = one on the gearbox and one behind the dashboard

may be security system - indicating that if radio removed from this vehicle, it will not work in another

Answerthe accelerator cable may be binding up causing a stiff pedal. check cable where it connects to throttle body. check cable at gas pedal, and where it goes through firewall.what could cause a stiff pedal gas in a 1993 Toyota Tercel with manual transmission?

It is on the top left corner of the throttle body, connected to a metal pipe. There is a sticker on the inside of the hood with a diagram of the vacuum system.

Check fuel delivery pressure Should be: at idle 13-20 psi with ignition on and motor off 23-31 psi

Man I wish i knew. I also wish I knew where it's location as well.

Under the intake manifold, right in the middle of the valley, on the block. The intake manifold has to be removed.

The 1993 oxygen sensor is the best sensor for a 1993 Honda Accord EX.

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.