0
1994 Ford Taurus Starts fine Put it in drive doesn't engage Put in reverse doesn't engage after doing this a few times it will take off What is the problem?
Wiki User
∙ 17y ago
your geers in your tranny are waring down and will cause the transmission to slip or not go into gear
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Your 2000 Plymouth starts but doesnt drive what could be the problem?
Try Putting It Into Gear!!!!!
Why doesnt 1998 Ford Taurus shift into overdrive?
The transmition is bad it happened to me its the overdrive selinoid also valve body problem possible, solenoid is on valvebody.
Where is the distributor cap on a 2002 Taurus?
it doesnt have one
Your car cranks sometimes starts sometines doesnt could this be a transmission problem?
THE netural Saftey Switch could B bad .
How do you know the problem is the alternator?
If your car doesnt start, it could be the battery. But if the car starts and you unplug the negative cable and the car turns off, its the alternator.
Does a 1993 Honda Accord have reverse threads?
no it doesnt
How does reverse polarity help geophysicists?
it really doesnt
Who should Taurus date?
it doesnt matter what a horoscope says. you will find love when it comes to you.
Current that doesnt reverse direction is called?
direct current
What can be wrong when a Mitsubishi GTO won't engage in reverse?
a common problem is a water coolant pipe or front air intake pipe obstructing the gear change lever on the top of the gearbox. a pain in the arse but easier to fix than a broken syncro. if you can get the car to reverse by holding the gearstick in reverse than this could be your problem. if its grinding than you have a damaged syncro, or your clutch doesnt dis-engage properly
87 ford ranger runs great cold but when engin warms up starts missing and cutting out comp check doesnt show any problems?
ignition coil.i had the same problem
How do you know if it is the solenoid or the starter that is bad on a Ford Taurus SE?
Usually you can bang on the starter with a hammer when it doesnt want to start and that will do the trick. It will engage and the car will start. If that is the case then the problem is the starter itself and not the solenoid. You can also remove both and take it into any Kragens or autozone and they will bench test it for free and tell you. You can also use the screw drive method by bypassing the solenoid and applying power directly to the started by laying it across the 2 terminals. if it starts then the solenoid is the problem assuming you have power to it.
