If you used the correct A/T fluid, then Check the fluid level according to directions spelled out in the owner's manual. If it is at the full level and still slips, then you need this transmission looked at by a professional. More likely than not, it will need an overhaul or replacement.
how to check the fluid on a ford freestyle transmission
It is possible, but not likely for a transmission fluid leak from the speed sensors.
The product should have a manual that lists the preferred transmission fluid for the equipment, and an instruction list of where to add it to the mower. It is advisable to use a funnel to add the transmission fluid without spilling fluid over the parts of the mower.
Maybe, 95 windstar has a different plug for transmission shift and the netrual safety switch ,But the plug for the trans can be changed,also you must have both in front of you to compare.95-97 ,98-01,your trans is an AX4N and uses syn fluild,,the car computer makes the trans shift.95 is an AX4S,I think it will work but as always you will have things to deal with.
ventricles
1 oz = 6 tsp 1 tsp = 0.16 oz
small intestine?
You can find fan fluid at your local auto parts store, it is in the same isle with the blinker fluid.
6.4 ounces.
10quart=320 fluid ounces 20quart=640 fluid ounces
You can find the dipstick for the transmission fluid of an automatic transmission on the passenger side of the engine block (this is where the automatic transmission is mounted). It is way down in there and somewhat difficult to see - a flashlight will be helpful in locating it. You need to be careful when checking it because it is easy to burn your arm on the radiator hose as you reach down in there to grab the dipstick. As for the engine revving, depends if it is an automatic or manual transmission. If it isn't the clutch or the transmission, it could be a faulty throttle position sensor, bad oxygen sensor, bad fast idle thermovalve, or many other things.
the only way to check trans fluid level on '02 explorer is from under the truck.. you will need a special tool to hold nut on drain plug while you unscrew the center screw which has a tube attached to it... basically you will add fluid till it starts to leak out, then you know you are full... hope this helps..