The Chevy Lumina vans are bad for stab link kits and lower control arm bushings. If you inspect the lower control arm See if the bushing has come free of its bonding. Also does your van have a 3.4 in it. Check to make sure the intake gaskets arn't leaking. Another major problem for this vehicle.
Behind coolent over flow tank passenger side under hood
It's a sensor that tells the computer if there is a rod knock in your engine.
Behind the dang motor
Take out the whole dash and then the heater core should be behind the glove box on the passenger side.
Behind the harmonic balancer.
if you dont have any oil in the cars motor that would be a reasin why its knocking
how do i remove the passenger door inside panel?
The fuse box is on the passenger side of the dash board open the passenger side door and you will see it on the side
Chevy Lumina has not the carborator.
The turn signal switch location on a 1991 Chevy Lumina is behind the steering column. You will need to use a socket set to get to the switch.
Where is the computer on a 95 Chevy lumina
I think it is behind the crank pulley.
It's located near the firewall by the passenger side of the car.
how to change rotors on a 2001 Chevy lumina
Its behind passenger side fendor. Behind the EVAP container.
behind the harmonic balancer
i had this problem the intake manifol gasket is blowed
Integrated into the power steering pump on the top passenger side of the engine.
passenger side. open the passenger door, look on the side wall that is covered when the door is closed.
1994 Chevy lumina freon type
Where is the crank sensor on a 95 chevy lumina car ?
How do you convert the ac in a 1992 Chevy lumina
yes it will fit