I assume you have checked/replaced the bulbs. Take a cicuit tester and check the wire harness connections under the bumper and around the trailer connector if you have one. The problem must be at that area IF all your other lights are working as you said.
either your fuse is blown or the wiring is bad
Check the brake light switch.
Check the fuse, check the bulbs and check the brake light switch, it should be one of those.
The 2001 Chevy Blazer brake lights may not work and the third bake stays on because the current light needs to be replaced. A replacement brake light can be purchased at an Auto Parts store like Pep Boys.
Yes they indeed have brake lights...
The center high mount led brake light unit has been known to go bad.
Just a suggestion, check your trailer lights harness for corrosion. They were taking the dash lights down in my chevy.
I can't turn the yellow brake or parking lights on my 1998 Chevy blazer off and it's draining my battery.Could you please tell me which fuse or switch I'd use to disable the front yellow lights? This is happening even with the car off.
On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.
Brake Lights Stay on Unless the Brake Pedal is RaisedThis is usually caused by the brake light switch being out of adjustment in its physical distance to the contact point on the brake pedal arm.
its probably not a fuse at all, but it could be your brake light switch. its under the dash hooked to the pedal. I had to replace one on my 84 t-bird
Directly above the brake pedal.
Check the bulbs they are double filamented -smaller for brake lights larger for tailights Check the fuse Check the stop light switch usually located at the upper end of the brake pedal under dash area
Ensure relays and parking brake switch are properly functioning.
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
check the multi function switch. I hava a 96 Chevy Monte Carlo and I had the same problem . I changed the multi function switch and the brakes lights now work. the rear brake lights run thru the switch on the turn signal circuit. try it and see.
The hazard switch and the turn signal and brake lights are all incorparated, chances are the 3-1 switch is broke internally check all fuses
It is important to have working brake lights on a vehicle. If the brake lights are not working a person should first check the fuse, bulbs and at last the wiring.
If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.
You can, but not while it's running. Before you turn your key, you have to set the parking brake, not all the way but just a bit and then start the Blazer and the lights should stay off.
you can find the switch on the back of the brake pedal.
on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that
the brake pedel pushes a switch right on top of the pedel lever it can come loose or go bad. check fuses first
the connection between the battery and the brake lights
It is your multifunction switch that has gone out. It is located in the steering column. I used my emergency lights and it blew out brake lights, turn signals, and emergency lights. In newer models Chevy did a recall not so for our older models. Mine is a 1995.