Start by inspecting the bulbs that don't light. Remove the bulb and make sure the contacts aren't corroded. If not corroded, change one bulb and test. If it doesn't work with the new bulb, then check the fuse(see owner's manual for which fuse is brake lights). If none of this works, check the activating switch located on the brake pedal arm.
The brake light in the rear window and the main brake lights are on a different circuit. After the signal leaves the activating switch on the brake pedal arm, it splits. One circuit goes straight to the high mount brake light, the other goes into the turn signal switch. If the rear turn signals work but the brake lights don't, suspect the turn signal switch, not the bulbs and wires. Better to check this before removing and checking bulbs, wires and fuses.
It is a common problem with the W-body cars like Lumina, Monte Carlo,Regal, Olds Cutlass and Grand Prix. (Approx 94-99 models). Part number is GM 190005031 (w/o radio accessory control) or 19005032 (with radio controls)
go to www.tss.likeabigdog.com =
Check sockets and grounds
Your problem may be with any or all of these three items: The fuse, brake switch or bulbs in the brake lights.
Its the steering colum
its either a fuse, or the turn signal switch needs to be replaced
brake light switch, it is typically located above the brake pedal somewhere on the brake pedal arm
How do you adjust the parking brake on a1994 Lumina?
It depends on the exact problem. If it's that both brake lights in the back do not work and the middle one works, it could be your turn signal switch.
turn signals work butt the brake lights dont can anyone help please? cant afford a mechanic.
you need to change the multifunctional switchthis happened to mine to
TRY TURNING THE EMERGENCY FLASHERS ON AND OFF A COUPLE TIMES THEN CHECK YOUR BRAKE LIGHTS. WORKED FOR ME.
It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.
Yes they indeed have brake lights...
Its most likely the brake switch. Its a plunger like switch on the brake pedal. Its pretty easy and cheap to change.
Possible bad stop light switch located near the brake pedal.
Remove the tire and wheel from your 1994 Chevy Lumina. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
I have a 92 lumina 3.4 Mine was above the brake peddle
Purchase the Haynes Manual for the Lumina it has all diagrams you may need.
You've got something wrong with your wiring, causing current to jump from the indicator circuit over into the brake light circuit.
possible air in the brake lines.
Check if the male and female plugs are snapped into place tightly. And check if the lights or fuse is burnt out.
Check the bulbs one of the 2 filaments may be burned out
Left, right and center high mount. See sources and related links below for more information on bulbs.
If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.
Go to AutoZone and look up your fuses in a book for the make and model.
on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that