1997 Chevy venture check engine light blinks?
If the check engine light is blinking that means an engine cylinder misfire has been
Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light. If that does not work an OBD 1 scan tool is required. Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light. If that does not work an OBD 1 scan tool is required.
In a 1994 Chevy lumina which ports do you ground in the diagnostic connector to get the check engine light to blink the bad code?
It means there's some fault code. Narrowing it down, you'd need to check to see what code it flashes at you. Key in the on position, diagnostic or cruise control switch on, hold your Set-Accel/Hold-Deccel switch and count the blinks on the check engine light... it should blink a three digit code at you... the number of times the check engine light blinks is the number, then a pause, then it blinks another number, then…
Low engine oil level - check and add engine oil Check the oil dip stick with the engine turned off and see if it is full. If so, then the sensor needs to be replaced. It is located at the bottom of the engine in the oil pan and has a wire going to it. All the oil will drain out when you remove it, so it is best to do it when you change…
I really need to know how you read a 700... i have never heard of it and cannot find it. if your check engine light shines a long signal that represents a 10, if it is short blinks they represent 1. you take your long blinks and add your short blinks. example two long blinks and three shorts is a code 23.