It's the bearings, the axle halves are held into the rear end at the ends. The bearing is pressed on to the axle and held on with a retainer plate. Sometimes after wear the bearing will become loose and the axle will begin to slip out. In the middle of the rear end the axles are splined and simply slip into the ring and pinion gears.
the front wheels have no bearings
near the front wheels on the upper and lower control arms
Check for vacuum leaks,
You need to check the u joints at the front wheels.
i know you can put 24 inch wheels on stock rotors
You need to check the u joints at the front wheels
...what about it?
Honda civic 1997 comes out with 175/65r14 size 14inch wheels Honda civic 1997 comes out with 175/65r14 size 14inch wheels
Dog on Wheels was created on 1997-05-12.
1997 dodge ram 1500 2wd 1500 engine block heater location
tighten up nut,and back it off 2 turns- should be able to get a bit of motion if you push and pull,be sure to pack bearings with proper grease
How do you remove the automatic shifter cablein a 1997 GMC sierra 1500