First check crank sensor again. A terminal gets bent sometimes during installation. Look at it good with a light. Then, VATS module, under dash, left of steering collumn, velcrowed in.
right behind and below the power steering pump on the block.
on the 3.1, it is under power steering pump. remove pump set aside ,do not remove hoses.once removed sensor is reachable!! there should be one bolt to hold sensor in!!
i do believe that the camshaft sensor on the 3100 v6 motor is on the passeger side of the motor underneath the intake manifold and under the powersteering pump. i needed to replace the one on my 1996 lumina with that same motor and that's where i fould it. hope this helps.
its located behind the power steering pump...you would have to remove the power steering pump to access it
the injector might be the wrong size meaning it might be injecting too much fuel check with the dealership
Where is hood open sensor on 2006 Monte Carlo
Where is the knock sensor on a 2000 monti carlo ss 3.8l
where is the crankshaft position sensor on a 2003 monte carlo
The speed sensor on a 1984 Monte Carlo is located on the output shaft. The speed sensor is typically driven by the gear of the vehicle.
Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.
The Vehicle Speed Sensor is located on the transmission.jd
Where is outside temperature sensor 2003 Monte Carlo SS