Mercedes-Benz E-Class

1998 E320 Just purchased 3 of 4 headlights burn when turned on Should the middle two be on or off when lights on?


Top Answer
User Avatar
Wiki User
2009-05-24 23:22:01
2009-05-24 23:22:01

The middle two lights should be on when you turn on the headlights.

User Avatar

Related Questions

Turn on your headlights and hazard lights, call 911

pretty much, if your impalas like mine, when you start the car, your headlights will come on, but you should have a little nob to the left of your steering wheel. it should be in the middle, if you pull it out, your lights will stay on, even after turning off your car, if you push it all the way in, your lights will turn off, you can also turn it to adjust brightness of dome lights and dash lights.

There are 2 filters. Both are located in front of the radiator between the two front head lights. Remove middle section of headlights and you should see it.

No. The one in the middle is a brake light, and should only come on when you put on the brakes.

Then the brake lights are out but the middle one still lights up. (:

yes the middle design lights closer to the grill are the fog lights, thos are turned on by carefully pulling the lighting switch. pull towards you. this lights turn on only when you have the corner lights on &of course the headlights, it makes a cool daytime running light system with corner lights on, that now a days cars have from factorys

It is not that kangaroos particularly like lights - but they are easily stunned by them. Being nocturnal, kangaroos have a tendency to jump out from the bush in front of cars and trucks at night. Sometimes they actually stop in the middle of the road, dazzled by the oncoming headlights.

The daylight running lights of a Ford Explorer can be turned off by using the manual headlight control switch. Place the switch in the middle position to turn the daytime running lights off. The headlights will then need to be turned on manually at dusk.

There is a light sensor located at the top middle of the dashboard, near the windshield. This will turn your lights on automatically if the lights are not manually turned on. However, if you drive under some street lights or a bright area, it can read this as daylight and turn the lights off. To avoid this, always make sure that your lights are manually turned on at night. This sensor also effects the interior lights. They should not automatically come on during the day if it is working properly.

No, it's not normal. Some 2003 Vibe's have automatic headlights triggered by a light sensor. If you leave the headlight switch in the middle setting between "on" and "off" they will come on by themselves when it's dark. If you turn them off the daytime running lights will still come on and the high beams will still work but the headlights won't come on automatically at night.

LIGHTS is *not* a band. LIGHTS is the legal first name of the singer LIGHTS Poxleitner.Valerie is now her middle name.

First you should make sure that the lights you purchased already have the harness that connects to the wiring that your stock lights were connected to(mine did so that's what i know how to work with). Second, if your lights are anything like mine, you should have 3 sets of wires on the bottom of the lamp housing( 3 sets of red and black wires). These wires go to the halogen halos around the actual lights of the headlight. I found it best to wire these wires to a toggle switch in the car that way your halos are not on all the time(which could cause them to burn out, they are mainly for show and to be all fancy and what not) and you can control when they are on. Third, your lamps should fit directly into place of your old lamps. There also should be wires to hook up the blinker light that is in your new setup. I have not take the time to wire these up yet. The bulb on the outside of the lamp is your regular light and the bulb in te middle is your brights. Nothing extra for this, just plug and go. Your neighborhood friendly focus freak.

the menorah and the nine candles are on it. the middle one lights the other eight.

Pull up to a wall/garage door and mark the relative middle of the headlights with a cross of tape on the surface (not the light but the actual physical height of the mechanism. Pull back at least 20 feet and adjust the screws till the lights are pointing to the lower inside quadrant of the crosses you put on the wall. Make sure your jeep is on a level surface or this will not work

Generally, pull about 10ft from a wall or garage door on level ground and turn your lights on. Adjust headlights by turning torx screws on headlight assembly so that each beam is pointing perfectly straight forward and about 2-3ft high off ground on wall/door. Probably closer to 2ft is better. Remember there should be 2 separate beams and measure height from middle of beam to the ground. This procedure is very general but will work for all cars.

the middle position of the 3 turns them off on my 01 S80

I'm not sure if fuses are your problem as faults would be found in several fuses to cover all the items you have listed. However, the Emergency flashers, turn signal lights are covered by fuse 7 (3rd row up, 3rd from right) in the Fuse box in the middle of the top of the dash. The instrument panel lights by 6 (1 to the left of 7). Left high beam by 27 (4th up, 2nd from right). Right High beam by 28 (to the left of 27). The other is in the 'front compartment' (engine compartment?) "STOP" by 33 (middle fuse/relay).

The little triangle on the dash, in the middle.

It is a common decoration in the Middle East during Ramadan.

I just purchased a 2011 sonata 1 week came with no owners orange symbol with a half circle on bottom and a thermometer? looking stick in the middle of the half circle popped up.what might that be?

No, all yearbooks have been purchased

They are gang from Birmingham who drive without lights on in the middle of the night. If you flash them they will shoot you. My advice is not to flash someone without lights on in hansworth.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.