2000 Windstar right high beam quit working so you replaced with known good bulb and still no right side highbeam?
check the fuse for the right headlight. it may be blown. YES, there is a fuse for each headlight.
Since the Windstar uses a timing *chain*, we do not have to worry about a timing belt. That really only leaves the "accessory drive belt" - much better known as the serpentine belt. 60,000 miles or when the hard-to-see wear indicator markings on the side of the tensioner show it's time. See "Related Questions" below for more
What could be the problem with the 1996 Ford Windstar front heater not working and damper acutator is working fine?
What would you do if a customer's wireless router requires constant restarts because it stops working?
90% sure of it. There is a known circumstance I read about once that could result in oil getting into the engine coolant... Had to be one of the Windstar forums or here at WikiAnswers, since the early 3.8l Windstar engines were so prone to head gasket leaks... In the meantime and back to the more common causes... It could be either a bad gasket or a warped head. Either way, the gasket is going…
Why would a gas gauge stop working on a 1993 Chevy Silverado truck after the fuel pump was replaced?
Chevy's are known for this problem, i just recently had the same problem and what you need to do is replace the fuel sending unit. My original problem had to do with my fuel pump not working and i wasn't really worried about the gauge but we figured since we had the tank down we might as well swap the sending unit and my gauge starting working. Good luck
bad blend door motor (should be clicking like crazy when you adjust the temperature knob). remove lower center console below radio and cupholders and you will see it. it is a square white little box held with screws to the blower case. they are known to go bad on the model...i have replaced qute a few of them already.