Ford Ranger XL
Thunderstorms and Lightning
Speed of Light

2000 ranger speed sensor 2wd 5 speed?

Top Answer
User Avatar
Wiki User
Answered 2007-01-18 21:09:48

Located on the rear axle housing and held by a mounting bolt.

User Avatar

Your Answer


Still Have Questions?

Related Questions

Where is the speed sensor on a 99 Ranger 2.5 liter 2wd auto trans?

The speed sensor on a 99 Ranger 2.5 liter 2WD with an automatic transmission is in the rear differential. It is included with the ABS sensor in one unit.

Where is the speed sensor on your 2000 F150 2WD V6 manual transmission?

ford speed sensor are usually in the differential housing.

Is a 1987 ford ranger 4 speed with over drive is it 4wd or 2wd?

A 1987 4-speed ford ranger with over drive is a 4wd and not 2wd.

Where is the speed sensor on a 99 Mazda b 3000?

I own a 2000 B3000 2WD. To date, all repais have been consistant with those of a Ford Ranger ( Same Truck ). There are two on the ranger, both on the drive train, a simple bolt on. One on the Trany, and one on the Diff. You can see them both..

What would cause the tachometer temperature gauge and fuel gauge not to work on a 2000 Ford Ranger XLT Fuse is good?

I had a 2wd 2000 ranger xlt and this happened to me. The part that I replaced is called a "speed sensor". It in an inexpensive and easy part to change out yourself. It is located on top of your rear end under the bed. A simple wrench will do the trick.

Does a 1997 Nissan pathfinder have a speedometer cable or speed sensor where is it located?

it has a speed sensor. its located in the transmission on a 2wd model and in the transfer case of a 4wd model

Where is the oxygen sensor 2000 Chevrolet S10 2wd 4 cylinder?

extended pickup

Where is the vehicle speed sensor on a 1995 s10 pickup?

The vehicle speed sensor on a 1995 s10 pickup 2wd is on the tailshaft of the transmission. The 4wd is mounted on the tailshaft of the front differential.

Which years of 5 speed transmission will work in your 93 ford ranger with 3.0 v6 and 2wd?

it will work in the ford

How do you change the ball joints in a Ford Ranger?

1998 2wd What year? 2WD or 4WD? 2WD 1996

Why on my 1995 Ford Ranger 2wd does the ABS light stay on I have changed the sensor in the rear end?

I wonder if one of the ABS fuses is bad ?

Where is the speed sensor location on a 2000 ford explorer 4x4?

Answeri think its on the back of the transfer caseNope, the motor on the back of the transfer case shifts the cheicle from 2wd to 4wd high and 4wd low. The speed sensors are located in the brake calipers on each wheel.The speed sensor for the front are located in the calipers but the rear is located in the differential housing.

Will a transmission from a 92 Ford Ranger V-6 5 speed 2wd fit a 92 Ranger with a 4 cylinder 5 speed 2wd?

Check with the local salvage yard that handles ford the 5-speed transmission from a 92 3.0 V6 4x2 will only fit 91-94's with a 3.0 V6 or a 94 Mazda B3000 m.t. 4x2

How do you change upper and lower ball joints on a 1992 ford ranger super cab 2wd?

how do i change a lower ball joint on a 1992 ranger 2wd

Where is the intake temperature sensor plug for a 2000 Kia Sportage 2WD?

It screws into the top of the air cleaner assembly near the braket for the mass air flow sensor.

Where is the speed sensor located on a 1995 Nissan truck 2wd 4-cylinder?

it is on driver side of trany on the tail end

Will a 1985 ranger 5 speed transmission bolt up to a 1987 4x4 ranger?

Automatic trannys are different. The tail shaft on a 2wd tranny is different than a 4wd because of the transfercase. If in fact the 2wd manual tranny does not fit a 4wd you can always change the tail shaft to make it work.

What is mpg for a mpg 2wd 2.5 Liter 1998 Ford Ranger?

19 city / 24 highway with 5 speed manual transmission ( U.S. gallon )

Does a 1994 ford ranger have struts on the front?

are there struts or shocks on the front of a 1994 ford ranger 2wd

Where is the vehicle speed sensor located on a Jeep Grand Cherokee 2WD 6-cylinder?

If it is a 1997 or older it is in the tail housing of the trans. If it is a 1998 or newer the speedometer signal comes from the rear axle speed sensor on top of the rear axle.

Where is the speed sensor in a 1999 Ford Ranger?

== == I believe on the 99 it is a simple bolt on sensor on the differential. Actuallly on the '99 Ranger the Speed sensor is near the transmission. There are manuals that point you in the direction of the differential, however, that is what is known as the ABS sensor. Why they call it the speed sensor in the manuals, I have no idea. Hope that is of some help. The speed sensor should be located on the right side of the transmission, about midway between the bell housing and the tail. There are 2 speed sensors one near the transmission and one near the rear axle. If your abs light has been on since the problem started then the one in the rear needs to be replaced; if this is not the case most likely the other sensor is bad. Simple if the speedometer doesnt work it is the one on the tranny...the 99 also had 4 wheel abs on some so there might be a sensor on the front spindle too I have a 99 ranger 2WD reg cab. A couple years back the speedometer started acting funny. It vibrated violently and displayed about 1/3 to 1/2 my actual speed once I got over 30-35mph. I replaced the speed sensor on the differential and this solved the problem. I'm guessing that if the speedometer doesn't read at all then it is the transmission sensor. However the differential speed sensor (ABS) may have speedometer symptoms as well. The part was about $17 and it took a socket and 5 minutes to replace.

Are 2wd and 4wd front brake rotors interchangeable on 1997 ranger 4L V6 XLT?

are 2wd and 4wd front brake rotors interchangeable on 1997 ranger 4L V6 XLT

How do you replace a u- joint on a Ford Ranger?

how to replace u-joints on 1995 ford ranger 2wd

What type of transmission fluid to used in a 2001 Ford Ranger 3.0l 2wd manual transmission?

Motorcraft MERCON automatic transmission fluid is used in a 2001 Ford Ranger 5 speed manual transmission ( yes - ATF )

1993 ford ranger manual 2wd mercon or sae80?

you can use mercon...