If your traction control light is constantly flashing and you are NOT drawing an OBD fault code, then the system may need to be calibrated. Ford can do this for $92. A system needs to be calibrated when a component of the traction control is replaced or disconnected and reconnected. If, however, the light returns, the problem is likely the clock spring in the steering column, also known as a "sliding contact." Ford/Lincoln is famous for these things not lasting long. It is the component that brings power to everything you need in the steering wheel (horn, cruise, air bag, radio volume, etc.). When this goes bad, it is tantamount to disconnecting/reconnecting the steering wheel position sensor (a component of the traction control). Typically, you will have other issues, such as a "high resistence" code from the air bag, or the horn or cruise will not work, etc.
When the traction light is on you have the traction control turned on in your vehicle and traction control is activated. Traction control is applying brakes to a wheel that losing traction.
Is it flashing or staying on? Flashing while stationary / start up - some sort of fault. Probably with braking / traction control. Flashing occasionally while on move - car skidding losing traction Staying on: Fault with traction control - I had this happen to me car would start, no light on, after a while light on all the time - turned out it was a broken wire. Staying on after pressing a button marked ESP you just switched off the Traction Control.
its the traction control light. more specifically its the traction control malfunction light
what about it? if its on, your traction control is on & working. if its not, then its not!!
on. if you cut traction control off the vehicle runs fine
your traction control light came on because either you turned off your traction control or your car needs brake fluid
The computer has detected a malfunction and set a code.
How to reset the service traction control light on a 2007 Chevy Sub?
To let the drive know that the traction control is on.
On my 2000 model focus, when the light is on permanently, this means the traction control has been turned off.
The Traction Control Light comes on every time you turn on the ignition. It should go off as soon as you start the engine. If it does not, then you have the traction control turned off. Turn it back on and the light will go off. If you have the Traction Control turned on and the light stays lit, then there is a problem with the traction control.
How to reset the service traction control light on a 2007 Chevy Sub?