Look on the battery installed to see what size it is. Ask any parts house. Look at Walmart's battery application book.
It is necessary to disconnect the battery to safely install a starter. When the battery is disconnected the radio loses its presets due to no power going to it.
You need a Group 24F battery. Make sure it has top posts. Cold cranking amps should be between 570 and 600. This battery is quite easy to find and should cost no more than $65.00 installed. You can do this yourself but install is usually free.
The 2009 battery was shipped with 12V / 532 CCA (Cold Crank Amps) battery.
The 1996 Toyota Camry starter is located near the front of the engine, at the bottom. You can follow the positive battery cable from the battery to the starter.
Any battery of the correct CCA will work just fine.
go to Century battery site and follow the instructions
radio code for 1997 Toyota Camry after i changed battery it did not work
Solenoid or battery *Check the alternator as well. When my Camry did that, the battery and alternator both needed replacement. -andey78
Most any 12 volt battery will work in your car.
It's under the battery.
The battery or/and some of fuses are dead.
The speedometer cable for a 2004 Camry?æranges in price close to $40 each. The cable should be installed by a professional.?æ
if your battery was removed and your radio is asking for code then you must contact your Toyota dealer. there was a code installed from factory that they may be able to help with. also when you get it fixed read your owners manual on how to change the radio code to one you will remember.
You have to disconnect the negative cable from the battery.
disconnect the battery cables. find the battery clamp and remove it. Lift the battery out, then set then new one in place. Install the clamp, then connect the battery cables.
It's on the left side of the battery, between the radiator and the battery.
Open it up and you will see what battery you need to buy.
like a boss
The rear speakers on the Toyota Camry require the screws to be removed. The speakers are then disconnected and taken out. The new units can now be installed.
If you had new struts installed, they may have been installed improperly
it probably needs a new battery