Car Starting Problems
1982-1994 Chevy Cavaliers
3.8 L No codes run's rough rpm's fluctuate between 670-820 Plugswires new Replaced the Crankshaft sensor but still same issue If placed in Drivereverse and let go the break car dies Starts up again?
Asked in Check Engine Light
Why does the engine light keep coming on for the crankshaft sensor when it was replaced?
Asked in Oldsmobile Intrigue, Crankshaft Sensors
Where is the crankshaft position sensor located on a 1999 Oldsmobile Intrigue and how is it replaced?
Asked in Nissan Sentra
Can you fix a broken Nissan Sentra crankshaft pulley?
Replace crankshaft position sensor in 1995 jeep wrangler?
Asked in Chevy Aveo, Crankshaft Sensors
Where is the Chevy Aveo crankshaft position sensor located and how is it replaced?
Asked in Toyota Paseo
Does a 1994 Toyota Paseo have a pilot gear in the crankcase?
What should be done to stop a oil leak from a 99 Chevy Metro crankshaft position sensor?
Asked in Cadillac Catera
Why is it when I replaced my ignition switch in my Cadillac Catera my car just cranks and cranks but will not start?
Asked in Car Starting Problems, Radiators, Thermostats
Why does my car surge and won't start replaced thermostat and radiator?
Asked in Car Starting Problems, Audi A3
My EPC light came on my Audi A3 and sometime the car will not start why?
Asked in Chevy Impala, Crankshaft Sensors
Where is the crankshaft sensor located in a 2007 Chevy Impala LS?
Asked in Saturn S-Series
Can a crankshaft sensor on a 96 SL1 go bad after the alternator has been replaced?
Asked in Crankshaft Sensors, Ford F-350
How do you replace the crankshaft position sensor on 2005 f350 ford powerstroke?
What could be wrong if a 1996 Buick LeSabre starts and drives then will not start again?
Asked in Chevy Avalanche
How difficult is it to replace the crankshaft sensor in 02 Chevy Avalanche?
Could the mechanic damage the crankshaft sensor while replacing the timing belt and pulley?
1992 dodge caravan with 3.3 replaced coil pack cam crank sensors fuel pump ok no blown fuses also replaced asd relay still no spark?
Asked in Kia Sportage
If you replaced the camshaft position sensor should you replace the crankshaft position?
Asked in Mitsubishi Eclipse, Mitsubishi Galant
How do you replace crankshaft sensor on 1998 eclipse?
You nee to remove the crankshaft belt pulley, after that remove the lower timing belt cover. When you do that, you will gain access to the sensor and you should be able to replace it. After removing the lower timing belt cover you may need to turn the crankshaft so that the timing blade is not in the slot of the crankshaft timing sensor. On mine for some reason it doesn't like to come off with the blade on there at all, but mine got bent and so I replaced it with aftermarket timing sensor blade.
Asked in Buick LeSabre, Crankshaft Sensors
Do you have to have a dealer put in a crankshaft position sensor?
Asked in Check Engine Light, Dodge Ram, Saturn S-Series
Replaced the crankshaft sensor as per the code check engine light still stay on cycle code and you still says chrankshaft senor Does any one know what it could be?
The crankshaft sensor code is generic for a general ignition problem. It can be the spark plug wires, or fouled plugs. Most likely, you have one or two bad ignition coils that need to be replaced (this was the case with my 97 SL2 with that code). In my SL2, I replaced both the 1/3 & 2/4 coils (about $80 total) and the code disappeared and hasn't been back since.