i have a 4 door that i thought was posessed.seatbelt always slidin while drivin,interior light goin on when ever.then i realised it was when i hit a bump on the driver side front.i looked in the door frame and theres a lil switch on the bottom that i believe is the problem.maybe replace that,or disconect it til u find 1.
To reset electric windows on a Peugeot 307, just disconnect the battery for a while. Following the battery disconnect, neither of the electric windows will operate.
Yes. Call them and tell them to disconnect service. OR... (and I wouldn't suggest doing this) ... stop paying the bill-- eventually they will disconnect you.
Electric automatic tran axle.
no,as it is against the law to ride an electric scooter on uk pavement as is for walking on.
Lock doors with electric.
No cable, speedometer is electric
If you are referring to an electric antenna, there should be a snap-connector to the motor assembly-just remove it.
No, the 1974 Plymouth uses a mechanical fuel pump mounted on the engine block. It does not have an electric fuel pump.
the sensor is probly bad or you have short in it
Remove the bolts and disconnect the wires and pull the seat out
disconnect the electric harness goop on die electric grease and plug harnesss back on it work ed for me
Electric doors?? Are you talking about door locks? If so, even though they are electric, you can still operate them manually. Disconnect the power to the door locks and they are then manual.
Hit it with a hammer...or disconnect the wires and reconnect them
Electrical located in the fuel tank
unplug your ECM B fuse that should shut it off
No. Freinds don't let freinds do shabby electric work. Do it right.
It is not entirely clear to me what you are asking, however I will answer the question I think you want the answer for. When the electric company technician unplugs the old kilowatt hour meter that will disconnect the electric power from your house of business. When the electric company technician plugs in the new kilowatt hour meter that will reconnect the electric power to your house of business. For his own safety before switching the meters the electric company technician will probably disconnect the electric power from your house of business on the power pole or in the utility transformer box before beginning the work. So, yes you will have no electric power while this work is being done.
Yes, if you disconnect the motor from the mains and connect it to a multimeter and you spin the fan an electric current will be generated.
The fuse is there to disconnect the supply when there is a short circuit, before any damage is done.
Go to this website. It will show how to replace the side mirror.
The electric windows on a 406 might behave weird if you disconnect the battery. But holding down the "window-down" on drivers side for 10 seconds or so should fix it.
Open the trunk and disconnect the electric wires there. Go in the back seat and remove the covers/unscrew them.
Hey Ricky==I think your car has an electric speedo and therefore no cable. GoodluckJoe Thats right no speedo cable, it is electric, but there is a speed sensor on the transmission hope that helps
Not if it was disconnected properly