it may be your turn signal flasher module. i had same problem, but it wasnt the bulbs, it was the ground/reground flasher module. 15 bucks at napa auto.
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
The timing or crankcase sensor needs to be checked and most likely replaced.
Aha, another one! Yes, our '99 caravan is acting the same way. I have checked the bulbs and fuses, both checked good. I even checked the wires with a volt meter. No power is getting to the bulb sockets.
The sensor may be defective/broken. I would have that checked or replaced.
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
Was the gasket replaced? Have you checked the hose and the heater core. Is everything tightened down?
battery need to be at lease 14 volts to be able to start
Break pads should be checked if not replaced. Check condition of rotors at the same time.
try to check down the brake pedal
from everything i have checked you cant find it cheap anywhere
I checked. It says name'sIpod Name is replaced by the name you registered the account!
Catalytic Converter ... needs to be checked and/or replaced.
This happened to me once - - have you checked the air pressure in the spare tire?
You have a broken wire.
I checked fuses and replaced blown fuses and now it won't start.
I would go to the high beam switch next (test not replace)
Hey Hatim==Take it to Aauto Zone and have it checked out GoodluckJoe Take it to Auto Zone and have it checked out.
have you checked the fuel pump relay
After having it checked by a competent, reliable mechanic. A rather endangered species these days.
Have the battery checked out. It may have a dead cell and not holding a charge,
It means that the low pressure switch is open. Check the heat pump schematic to see if it is supposed to be an open or closed switch. Schematic electrical drawings are drawn in the de energized position. This means that when there is no voltage applied to the device, this will be the position of relays and contacts.
You didn't mention if you checked/tested the low beam headlamps or not.
== it comes either in books or card pack's is not available anywhere i have checked. Save ==
it differs on what you eat. But if you are trying to have a kid, and your not getting anywhere you might be low. i would get that checked out!