0
94 jeep Cherokee loses while driving but regains power sometimes or it goes dead and it sometimes will not crank back up?
Wiki User
∙ 16y ago
it, sounds like the crank sensor needs to be replaced or throttle body sensor needs to be cleaned.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
2001 jeep grand Cherokee won't start sometimes?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
Why does a 1999 Jeep Grand Cherokee 4.0 2wd dies while driving and after few minutes starts again?
crank sensor ?
1990 Buick LeSabre when I am driving it cuts off and sometimes it'll crank back and sometimes it takes a long time I was told it was my coil pack?
My 90 lesabre did the same thing. When it cut off after driving I sprayed water on the crank sensor and it started right back up. A buick mechanic told me to do this and this is how I found out the crank sensor was bad!
What would cause a 1998 Cherokee to stall while driving and not start not even push starting it?
Check the crank angle sensor usually about $150 to replace
Could the Crank Shaft Position Sensor cause a 1999 Jeep Grand Cherokee Laredo to stall driving up the road doing 65?
Yes
If a 92 Jeep Cherokee will crank over but will not start what is the problem?
probably crank sensor, they are famous for that
Your 1995 jeep Cherokee Laredo dies on you sometimes 2-3 times a day it takes a while sometimes but always starts back other times it drives fine for days without quitting what is wrong?
Check the crank sensor, i had the same problem with my 94 Grand Cherokee
How much crank power does a Jeep Cherokee need?
a jeep Cherokee need 220 volts to run
Where is crank sensor located on 99 Cherokee xj?
The crank sensor is on the top driver side of the bell housing.
Why does an explorer crank but won't start sometimes?
bad crank sensor
Where is crank position sensor located on 96 Cherokee?
In the underside on the far left
Will crank position sensor interfer with ignition module on a 1994 jeep Cherokee?
The ignition module uses the crank sensor to decide when to spark.
