Car Electronics and Lights
Headlights Tail and Brake Lights
Chevy S-10

95 Chevy S-10 5 speed reverse lamps do not work good bulbs and good fuses?

161718

Top Answer
User Avatar
Wiki User
2009-10-15 23:16:57
2009-10-15 23:16:57
Answer

There is a switch that may need to be replaced (generally referred to as a "back up light switch")

Its located on the driver side of the transmission roughly about half way between the front and back also to the middle of the transmission.

It's easy to do it yourself and on average takes about 5-10 minutes.

The part costs about $10 to $15 or so.

I recommend a 15/16 deep well socket as well to speed up the process.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

check the fuse's first. then check the lamps [bulbs].....

User Avatar

check the switch on the transmission. check the bulbs and the fuse.

User Avatar

what does that question mean?? did you check fuses ? head lamps only or all lights ?? be specific

User Avatar

Check the fuses in the power distribution box under the hood.

User Avatar

In electrical terminology bulbs and lamps are the same thing. If you are talking about a lamp as a fixture no bulbs and lamp fixtures do no need to be sold together.

User Avatar

Need to clarify what you mean here. If you're referring to the lights themselves, both of the two bulbs in the top of the tail lamp housing are dual filament bulbs, which serve as parking lights, turn signal lamps, and brake lamps.

User Avatar

Typically city transportation employees change the bulbs in street lamps approximately every 3-4 years. For the high sitting lamps, a mast is raised and the bulbs are replaced, usually during the daylight hours.

User Avatar

Lamps using LED bulbs are more energy efficient than lamps that use traditional light bulbs. LED bulbs last over 25 times longer than regular light bulbs. Though they may cost more at the outset, the cost of usage of LED lamps is much less over time.

User Avatar

Modern table lamps use all sorts of different light bulbs. Most commonly one can find standard 20 watt to 250 watt light bulbs in modern table lamps.

User Avatar

LED lamps consume less energy that incandescent lamps.

User Avatar

By far the new LED lamps have a longer lifetime than incandescent lamps.

User Avatar

In electric lamps of course!

User Avatar

They are known as CFL bulbs. It stands for Compact Fluorescent Lamps.

User Avatar

check your bulb sockets for cleanliness, Check for a bad ground wire.

User Avatar

Although they are larger than incandescent bulbs and cost more to produce, fluorescent lamps are more energy efficient and have a longer life.

User Avatar

Without light bulbs, we would still be using gas or oil lamps. Without those lamps, we would be in darkness for half the day.

User Avatar

If the lamps are connected in series, then all the other lamps would go out. If the lamps are connected in parallel, then the other lamps would remain on.

User Avatar

Check to see if the parking/dash lights work - if not check the fuses Could be burned out bulbs - they are double filamented with the larger filament being used for tail lights Could be a bad headlight switch

User Avatar

You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.

User Avatar

If your reference to bulbs is light bulbs then yes they can be mixed. The led lamps have to be ballasted to use them in home lighting.

User Avatar

try replacing your bulbs and check sockets for corrosion or possible loose wires try wiggling the wires

User Avatar

Bad Fuse Bad Bulbs Bad Ground bad Relay


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.