Ford Explorer
Check Engine Light
Ford Explorer XLT

97 ford explorer engine light still on after changing bank 1and 2 o2 sensors?

353637

Top Answer
User Avatar
Wiki User
2008-03-27 16:08:46
2008-03-27 16:08:46

TO reset disconnect battery positive side for 1 hour. Reconnect and let idle for 2 to3 minutes drive for approx 100 miles to reset all required paramiters.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There are sensors all over the engine that can turn the check engine light on.

User Avatar

After the Explorer is scanned for trouble codes to diagnose and then repair the malfunction , then the check engine light can be reset

User Avatar

Not unless one of the sensors was damaged.

User Avatar

Every sensor on the engine and transmission can cause the light to come on.

User Avatar

The check engine light is the light shaped like an engine, or the light that states Check Engine (Soon). If this light comes on, it is time to see what the issue is with the engine.

User Avatar

According to the 2000 Ford Explorer Owner Guide : No , a separate fuse for the check engine light is not listed

User Avatar

No, diesels don't have O2 sensors.

User Avatar

Yes but the check engine light will be on.

User Avatar

If the check engine light it on a 2002 Hyundai Accent on one of the sensors is malfunctioning. The computer is acknowledging this and alerting the driver that there is a problem in the engine.

User Avatar

On a 1997 Ford Explorer : CHECK ENGINE is just to the left of the " C " on the engine coolant temperature gauge ( Helpfull )

User Avatar

There are dozens of sensors that can turn on the check engine light. You need to have the codes read with a scan tool, and can than ask a question with the code number.There are dozens of sensors that can turn on the check engine light. You need to have the codes read with a scan tool, and can than ask a question with the code number.

User Avatar

The light that shows an engine symbol is your check engine light . If the light stays on while the engine is running, the OBD II system has detected a possible problem with your emission system. If the light flashes on and off, an engine "miss" has been detected . Have your Explorer scanned for any trouble codes to find and then repair the problem.

User Avatar

If the check engine light is flashing that means an engine cylinder misfire has been detected

User Avatar

Then you may want to have a mechanic check it out.

User Avatar

Yes a bad senser in any vehicle will turn your engine light on. Even a performance air intake will turn your engine light on.

User Avatar

If your check engine light is staying on with the engine running , a malfunction has been detected with the emission control system . Have your Explorer scanned for any trouble codes to diagnose and repair the problem

User Avatar

There are dozens of reasons. But in most cars of this model some sensors just become old and have to be replaced. When sensors fail ECU sets off the check engine light.

User Avatar

There is not one sensor. All the ECM sensors are tied to the check engine light.

User Avatar

There are a lot of sensors that can trip the engine light, you would have to scan it to know which one is causing the error

User Avatar

I had all sensors replaced in my 03 Trailblazer and the check engine light stiil comes on. Why?

User Avatar

light sensors are used in cars, televisions and computers. there are different types of light sensors.

User Avatar

engine management warning light,,,a fault with one of your sensors

User Avatar

Your VW Beetle check engine light comes on when there is a problem with one of a number of sensors on the vehicle. Take the car to the dealership to have them determine the engine problem and reset the light.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.