answersLogoWhite

0


Best Answer

remove rims remove hubs then the 2 jam nuts pull of sproket before that loosen chain the pull axle strait out pretty simple

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Any tricks to remove rear axel from Yamaha warrior?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove a Ford Drive axel?

how do you remove the axel after taking out an alternator


How do you remove rear tire on a Yamaha royal star?

Simple, remove both saddle bags, jack up the bike, loosen the swing arm tent ion bolt ( on the right side) remove the bolts that hold the brake cal. And the bracket that holds it on. Loosen the axel bolt from the left side ( watch the jack height, jack up just enough to take the pressure off the tire) remove the bolt and pull the axel out from the right side ( spinning the axel as you remove it will help) once the axel is out , jack the bike to the highest point and remove the tire(you will have to lean the tire to the side to clear the frame. And that is it. I just did it on my 06 RSTD good luck.


How do you get the rea rend gears out of the diff box?

depends on type but generally you remove cover ,remove pin locking bolt 5/16" or 8mm ,remove spider pin then push axel inward ,remove "c" clip from axel then pull axel out this allows you to remove gear ball caps and remove gear ball, then pinon comes out through back


Front axel torque specs for Yamaha grizzly ATV?

For a 2002 the factory spec is 190 ft/lbs


How do you remove axle shaft onb daewoo cielo?

how do i remove the axel shaft off the daewoo cielo


Have a 89 Chevrolet 4x4 trying to get the axle out how do you go about it?

If its the rear axel you have to take off the rear end cover. Turn the gear assembly until you see the bottom of a round pin. I goes all the way through so you may have to look at both ends but one end will have a bolt coming in from the side. Remove that bolt and slide the pin out. Once the pin it out you can push in the axel a little more and then remove the C clip that retains the axel. Depending on the position of the clip when you push in the axel the clip may fall off. You should be looking at the end of the axel when you push it in to see if it fell off or you have to remove it. The easiest way to remove it is to use a magnet. Once off the axel will slide right out. Reverse the direction to install.If its the front axel you will have to remove the wheel, take off the axel nut, take off the brake caliper, support the lower control arm with blocks of wood or a jack stand. You will need to put the weight of the vehicle pushing down on the control arm to keep the spring in place. remove the upper ball joint nut and separate the knuckle from the ball joint. Next go in to the other side of the axel and remove the bolts around the flange on the center section. The axel with some bending and turning should come out.If the axel in the front is a solid straight axel like the rear just use the same directions as the rear.


What actors and actresses appeared in The Viking Sagas - 1995?

The cast of The Viking Sagas - 1995 includes: Axel Cortes as Warrior Gaukur Gunnarsson as Warrior Raimund Harmstorf as Valgard Hans Martin Stier as Mord Ralf Moeller as Kjartan Baldur Sigurdarson as Warrior Atli Sigurdsson as Warrior Gunter Ziegler as Viking on the Roof


How do you change a cv joint on a 1999 Mitsubishi eclipse?

beleave it or not its cheaper to buy the axel than jusy the cvjoint, its not that hards to replace an axel, you need to remove the tire on that side, you will see a big nut in the center of the wheel that is your axel nut take the nut loose then you will need a hammer drive the axel thru until it is free, then you will see your strut theres 2bolts running thru the strut remove the 2 bolts after removeing the bolts from the stut pull down on the spendel and release the axel after the axel is free from the spendel grab the axel and pull it out of the trasmision not sometimes it can be hard but it will come so don't be worred and to replace the axel do everthing in revers.note after replaceing the axel the car has to be lined up you can call the parts store and they can tell you how tight the axel nut has to be. i hope this will help you


How do you remove the axels in a locking differential?

There's usually a "c" clip around the rod of the axel you pop the c clip loose and the axel should slide right out of the differential


How do you remove a 1997 Dodge Avenger V6 passenger side CV Axel cant get the inside end of the axel to come apart?

Pull harder. If necessary, use a prybar.


How to remove Nissan Maxima axel?

what year maxima? please email ttrung1979@yahoo.com In i can tell you how to do it..


How do you remove the rear brake drums from a Toyota Tercel?

There are two types. If there are two scxrew holes in the face of the drum, run the appropriate sized screw into them and force the drum away from the axel. The newer ones require you to remove the nut and axel bearing, then it comes off easily.