answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2014-11-24 08:42:33
2014-11-24 08:42:33

If you are asking about rear axle gears, no. The XJ has a corporate axle and the ZJ has a Dana axle.

012
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A 1998 Jeep Grand Cherokee has a four speed automatic transmission.



Your going to have to get your transmission rebuilt or get another put in.


Make sure it is not just a sensor. Jeeps tend to have problems with sensors.


Clicking sound in grand Cherokee can be due to a faultyÊ actuator, or a cracked door. Actuator may causeÊ a clickingÊ sound when one of its plastic gears is broken.


im having the same problem now as we speak. i was told it was the shift solenoid located in the transmission.


try changing gears on the gear changer. nothing else change TPS


Most are interchangeable, I used a Cherokee Steering Gear on my Wrangler. :) The numbers are on the top of the gear. If they match and/or if it looks exactly the same as yours, in every way, it will probably work on your vehicle. There were also some Light Toyota Trucks that had the same gears as the Cherokees' too.


Spider gears do not have a ratio. The ring gear ratio could be between 3.07 to 4.10.


about 7 quarts put 6 in and run threw the gears and then leave it run in park run in 15min ad as needed to the safe mark


Tooth count depends on the gear ratio.


It depends on the brand. A lathe could be supplied with anything from two to seven separate interchangeable gears for thread cutting purposes. If you are asking how many gears a single standard center lathe has in total, the number could exceed fifty.


The spider gears in the differential allow the axles to rotate at different rates. It is likely that the spider gears or bearing have failed. Jeeps in general have a high rate of bearing failure in the rear end.



Multiplying Gears- a device that increases the rotational speedReducing Gears- a device that decreases the rotational speed


well, halo is famous and worldwide, but gears is a better game my vote: gears


Earle Buckingham has written: 'Gear ratio tables for 4-, 6- and 8- gear combinations' 'Spur gears' -- subject(s): Gearing 'Production engineering' 'Design of worm and spiral gears' 'Principles of interchangeable manufacturing' -- subject(s): Protected DAISY 'Principles of interchangeable manufacturing' -- subject(s): Accessible book


Gears of War 2 the last day is a trailer for Gears of War 2.


There isn't one according to my 1996 Jeep Grand Cherokee Limited Owners Manual. My Jeep has the vehicle system display screen with the green light Jeep. The manual says that there is a reading that can report a problem with the transmission temp, but when my torque converter and then transmission failed there were no indications or lights. It would sit and idle with no codes or lights and not shift into forward gears, reverse only.


Spur gears are cut with straight teeth. They can only transmit rotation between parallel shafts, and are relatively economical. Bevel gears have teeth cut on an angle. They transmit rotation between non-parallel shafts. Helical gears have curved teeth. They are generally quieter than spur gears, but are generally more difficult to make and more expensive.


You oil the gears in between the two silver big gears until the are sparkly clean. Keep oiling the gears until they literally sparkle.


Spider gears are the side gears in a differential - the little gears that divide the input power between the two wheels.


Are you stupid? of course it's not!! Gears of...War---Halo...3---Grand...Theft Auto. Who told you it was real!?





Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.