Headlights Tail and Brake Lights
Mitsubishi Galant

Are the headlight bulbs on the 1999 to 2003 Mitsubishi Galant the same?

Be the first to answer!


Be the first to answer!

Who doesn't love being #1?

Be the first to answer this question.

Related Questions

on 1999 Mitsubishi galant the transmission have stop working it don't go front or back what can I do to fix it.

where is the thermostat located on 1996 mitsubishi galant 4 cyl

show me in a picture where is the starter for a 2001 mitsubshi galant

No. Mistubishi Galant is year specific from 99-2001.

To deactivate the alarm system on a Mitsubishi Galant 1999, place the key into the ignition and turn it slightly. Leave the key in this position for 10 minutes and then start the car.

My model year 1999 Galant gets 28 MPG.

The dimensions of the trunk are not given in the online specs for the 1999 Mitsubishi Galant. The total length of the car is 187.8 inches and the trunk has 14.0 cubic feet of space.

To change a headlight on a 1999 Acura TL open the hood and locate the bulbs which are plugged into the housings. Loosen the bulbs and pull them off. Replace them.

in the thermostat gousing under the throttle body

where is bank1 sensor2 on the 1999 Mitsubishi montery sport 3.5

on the upper left side of youre firewall

It is mounted on top and inside the fuel tank.

No, they do not. This applies for the model years 1999-2001

Get a manual on your car and it will give you the procedure.

I have a 2001 Mitsubishi galant that has 146,000 and still going strongAnswermitsubishis suck, but as any thing it lasts as long as you take care of Jim My 2000 Galant has 172xxx miles and still runs like new. The average miles for a Galant is about 250xxx.

Is behind the front board, right behind the stereo

Thermostat on 1999-2003 Galant V6The thermostat is located on the driver's side top side of engine. Follow the bottom radiator hose located on driver's side up to thermostat housing.

Remove the entire headlight assembly to gain access to the bulbs.

depending on the engine code(in the vin)mine is a g code 2.4 and its built into the distributor

There aren't headlight covers, it all one unit. One of my lens was cracked and I had to replace the whole unit.

there is 3 10mm bolts on each headlight all you have to do is loosen then all and they will pop loose and there own no bumper removal necessary

Behind the bumper underneath the left headlight, except for the 4-door and the 1.8L models, where it is underneath the right headlight.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.