the cabinet bed (a bed that folds up into the wall)
The bed of a lathe is the central beam that runs down the machine. The head, which holds and turns the workpiece, is fixed at one end, there is a tailstock at the other end which can be adjusted along the bed, and usually a carraige in between, which holds turning tools. The workpiece that can be turned in the lathe is limited to what will fit in the head without hitting the bed. A gap bed lathe has a gap in the bed near the head, so a larger workpiece can be turned.
The bed length of a lathe is the total length of the bed way from where it starts to (close to the headstock) to where it ends. When a lathe is advertized for sale it would show for example: 200mm x 1000mm or 8" x 40". The 200mm or 8" describes the "swing" of the machine and the 1000mm or 40" describes the workable distance between the chuck and center. This should not be confused with the bed size of a lathe as the bed houses the tail stock and therefore the distance is shortened.
If the bed lamps use a low voltage bulb then the type of transformer will be a step down transformer.
in bed
my question is . rajisthan b.ed . entrance exeam result 2009 .
sndt bed result
when will forword your bed entrance exam form. pls reply this
when is the pune university bed 2009 exam result
result of Bad Examination held in Oct 2011 in S.N.D.T university ?
B.Ed result 2006-2007
Final Exam of B.Ed 2010 will be strart from July 22, 2010. B.C. Kumawat RIE Ajmer
Date of b ed results
ou bed exam time table
bed exam date in jnvu
BEd exam time table 2009
neelam gangwar year 2007-8 bed entrance but my roll number miss