A Dodge mechanic.
You can purchase the sub frame bushings on line for about $40.00 each. You will need 4. The job itself takes about an hour at your local mechanic. Then you will need an alignment. It's about $100.00.
you havn't taken it to the mechanic yet.
Good Luck! Just had this done by Chrysler mechanic, took him 7 hours labor and cost me over $700. Brilliant engineering by Chrysler.
A 1988 Chrysler Fifth Avenue
The leak detection pump switch on your Dodge Intrepid is located beneath the battery. If you can not locate this on your own, it may be best to have a licensed mechanic take a look at it.
It could be bushings but, if you do not believe your mechanic maybe you should get a second opinion.
A heater blower in a 2005 Chrysler Pacifica is a complicated process. To get this [project done, you will have to go to a mechanic and have it done.
after having car diagnosed by a Chrysler mechanic for $70 I was told that the light was on because the car needed the EGR valve for $406.00
I had same proble with my car just today. Mechanic asked me to replace brake boosters and also might be need to replace perportional valve. These parts are only available from a dealer and because of weekened i was`t told that how much does it going to cost me.
A mechanic can reset a Chrysler Town and Country ECU for you. If you would rather do it yourself, you will need to purchase a OBD scan tool and follow the prompts.
You will need to take it into a mechanic. They will be able to provide you with the parts that are needed to do it right.
This means it is a generator fuel control problem. You need to take it in to a mechanic to have it fixed as you could have stalling problems.
My suggestion would be to take it to a mechanic and pay the 50-60 bucks and some sort of guarantee!
There are thousands of reasons this could happen and not diagnoiseable unlesss it is doing it when the mechanic has it.
The engine on a 99 Chrysler Cirrus will turn but not start if it is not getting enough fuel or has no spark. Both issues can be diagnosed by taking the vehicle to a local mechanic.
no u have to pull it out and go inside to fix it i am a mechanic for coles auto! i hope this help u
Replacing the lower ball joint on a Chrysler Sebring is not the easiest thing to do. The best option for replacing it is to seek out a chrysler dealership or go to a professional mechanic that knows the specific car model and have done this type of work before.
Either have him replace it or get a second opinion.
Not recommended. Use only ATF+4
PO731 Gear ratio error in 1st gear. Possible causes:Low transmission fluid levelTransmission fluid dirtyDefective shift solenoidsTransmission hydraulic control circuit problemMechanic Problem with transmissionHave the transmission fluid and filter changed and if the problem does not go away seek professional help.
There are multiple reasons why the passenger heater on a 2007 Chrysler Pacifica may not work. it could be a heater coil, a fuse, or the blower. A mechanic can help figure out the specific reason.
Go to the local library and check out an auto mechanic manual for that vehicle. Hanes manual
The easiest thing to do would be to bring it to a local mechanic. They will be able to figure out why the door will not open and fix it without further damaging it or the car.
My mechanic told me they use Gold type antifreeze.