I tried all the fuses, the parts that under the brakes I checked that. All lights come on and working except the brake lights no break lights.
signal lights not working.
MAYBE YOUR BREAK SWITCH ON BREAK PEDAL IS BAD OR MAYBE A GROUND BUT I WOULD DEFINATLY CHECK YOU BREAK SWITCH
One or both your break lights are no longer working.
All motor vehicle lights must be in working condition. Head lights, break lights, tail lights, and even the light above your license plate must have working bulbs. Also if the casing is broken the appropriate colored tape must to put over to illuminate the needed color.
cavalier break lights not workin no indicators neither help fuseis gud do i need to change panals were bulbs go or what????????????
Check/replace bulbs Check sockets for power, ground, corrosion
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
Tail lights and break lights are different things pretty much all the time. You see, tail lights run all the time the car is on and break lights only turn on when the break is pressed. If you would like to find out which lights are the breaklights, have a friend watch the back of the car, turn it on, push the breaks a few times and see which lights flash. The lights that flash are your break lights!
Since the break lights turn on when the head lights are activated, the problem is probably in the wiring of your break lights. Someone may have accidentally disconnected the wires of your break lights to your head lights.
If the motors are working, then there has to be a problem between the motors and the lights. If they are only "working" though if you bench test them, and they don't actually do anything when you turn on the lights, then there must be an electrical problem such as a break in a wire or a bad ground to the motors.
it connected to a break lights switch, attached to a break pedal
If a Passat 04 TDI's indicator lights are not working, check the fuse. A blown fuse can cause the lights to stop working.
Blown lamp or fuse. Poor connection. Switch not working. Break in circuit
Break lights come on when you step on the break, they do not come on when the head lights are turned on.
Check the fuse box in the engine compartment. If that doesn't work, check the break switch located behind the break pedal. Sometimes those get stuck.
crown Victoria blower not working and head lights.
my lights are not working when i changed the pads on my peutgeo partner van
Your break lights could stop working for several different reasons. First statr by checking your fuses, if they are good then check the bulbs, If both of those things are ok then look to see if your break switch is operating properly, it may be stuck.
Hello, all you have to do is turn the back of the light post and pill the lights out for both the fog lamps and the break lights. For the break lights, its less work to change.
If parking lights and dash lights are not working and fuse blows out, there might be a problem with battery corrosion. Check the components specific to the circuits of the affected lights. It might be loose.
lights are very dim
Bad bulbs can be the cause of your reverse lights not working on your 1999 Toyota Tacoma. A problem with the reverse switch or bad wires can also be the cause of your reverse lights not working.
The most common reason that your dash lights and taillights are not working on your Pontiac Grand Am is blown fuses. Replace the fuses.