0
Can a 125V and 30 amp plug be used for a device that requires 24V and 50 amp?
Wiki User
∙ 12y ago
No. If you plug something that needs 24 volt into a 120v socket you will probably ruin your device.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can a 7a 125v power cord be used in China which is 240v?
No, it cannot.
What is a 15 amp hookup?
A plug and play 15v amp circuit is one that you can simply plug in. It has a three pronged plug so no special wiring is needed.
Can a 30 Amp 125 V plug be replaced with a 250 V plug?
In North America the answer would be no. The pin configurations for voltage and amperage all differ. This is so that an under voltage or under current device can not be used on higher amperage's and voltages.See related links below.
What is a device used to open and close an electric circuit?
The device is called a switch.
What is a commonly used alarm device for monitoring motion indoors?
A motion detector is an alarm peripheral that requires an alarm control panel to receive signals, which can trigger a siren and begin communicating with the central station.
What is the difference between 125V 15A fuse and 230V 15A fuse?
The voltage rating of a fuse (in this case 125V or 230V) defines the maximum circuit voltage that the fuse is safe to be used on. A fuse with a voltage rating of 125V should not be used in a circuit with a voltage greater than 125V. If a 125V fuse were installed in a 230V circuit and an overload current occurred, the fuse could explode.
Can a 7a 125v power cord be used in China which is 240v?
No, it cannot.
Can you use a 12v power adapter when device requires 6v?
No, twice the voltage applied to a device that only requires 6 volts will probably destroy the device. When a manufacturer of equipment states a required voltage for a device that is the voltage that must be used.
What can an LS-18 7A 125V Longwell cord be used for?
The cord can be used with Dell Alienware Laptop adapters.
What is the difference between device drivers and plug and play?
Technologies that support plug and play allow to connect new devices to a computer. After a short while, these devices can simply be used. When they are no longer needed, they can be disconnected again. Plug and play does not require the user to load a specific device driver to access the device.
How is microphone used as output device?
A microphone is a source that sends an output to its male plug. A loudspeaker is a load and receives an input at its female plug.
What is the device used to bore holes through cork or rubber stopper?
Plug Hole I Think :)
Measurement for mounting wall plug-ins?
Generally twelve inches from the floor to center of the device is used.
What term is used to identify a device that can be installed without restarting a system?
Plug 'n' Play (PnP).
Where does heat generated by a glow plug get directed to?
The heat generated by a glow plug gets directed to the cylinders. The glow plug is a heating device mostly used to help start diesel engines. It is pencil shaped.
What is a drain plug gasket?
A drain plug gasket is a washer type device made of plastic or other non porous material and is used between the drain plug and the oil pan to prevent leakage when the drain plug does not fit snugly in the oil pan
Can you use an AC adaptor with 9v output and plug it into a device that has 5v input?
No the voltage gap is too wide. If the higher voltage is used there is the possibility that the connected device might be destroyed.
