0
Can a 1994 sierra z71 transfer case be removed and replaced with a drive shaft to become a 4x2?
Wiki User
∙ 12y ago
YES. But you will have to get a 2-wheel drive 4L60E transmission to replace the 4-wheel drive transmission. Reason is that the center shaft that's running through the 4x4 transmission is longer so the transfer case will slide up on it. The 2-wheel drive center shaft is shorter cause there is no need for a transfer case.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Will a transfer case from a 2001 GMC Sierra fit a 2003 GMC Sierra?
YES.
Will a transfer case from a 1998 GMC Sierra fit a 2003 GMC Sierra?
NO.. They are a different type.
Is there going to be a new Ford Sierra?
no. it has been replaced with the mondeo.
When did Sierra Leone become independent from its colonists?
Sierra Leone become independent from its colonists on April 27, 1961.
What is the transfer case capacity for 2002 GMC sierra pickup?
2.3 QTS.
Remove interior door panel 2006 GMC Sierra?
The interior door panel, on a 2006 GMC Sierra pickup truck, can be removed by removing the retaining clips. The door handle should also be removed.
How do you repair an oil leak at the front transfer case on a gmc sierra?
replace the seal
What connection do sierra Leone have with African-Americans?
Sierra Leone was the first African country to become independent from a European power.
Dropped top dental plate. Where can I get it fixed or replaced at a low cost and quickly in or near Sierra Vista, AZ.?
“Dropped top dental plate. Where can I get it fixed or replaced at a low cost and quickly in or near Sierra Vista, AZ.” Dentures in 1 day for $168. Name of office and address and phone number. In Tucson or Sierra Vista, AZ
How do you replace the grill on a GMC sierra?
The grill on a GMC Sierra truck is replaced by removing the surrounding trim and retaining bolts. The grill is then pulled from the vehicle and a new grill put into place.
Where is the oil pressure sending unit located on an 2003 gmc sierra 6.0?
It is located on the back of the block, right below the intake manifold, on the right side of the motor (looking from the front). When I found it, I couldn't actually see it. The intake needs to be removed to be able to see the OPSU and replaced.
92 Sierra died on the road thought it was the fuel pump and replaced it and the filter now it seems there is no spark along the line?
Same thing happened to me. 92 Sierra 5.0, it was the ignition control module ~$50.00
