Yes. Most accelerator cable can fit as long as the lengths the same. You may need to adjust it by clipping the end
The cable or lock connected to the cable is not working. The body or trunk is bent.
Follow the positive battery cable ; it will lead you to the starter. Mark
Unplug the tire pressure light cable.
The accelerator cable is connected with a swivel nut on each end of the cable. Loosen the swivel nut, by turning it to the left. The accelerator cable will come off. Reverse the process to install the new accelerator cable.
The 1985 Chevrolet Corvette accelerator cable is held in place with a swivel nut on each end of the cable. Turn the swivel nuts to the left to remove the cable. Reverse the process to install the new accelerator cable.
Your 1983 Chevy Silverado accelerator cable is held in place with swivel nuts on each end of the cable. Connect the accelerator cable and secure it by turning the swivel nuts to the right.
Remove the negative battery cable then follow the posative cable and find the starter. remove the wires and mounting bolts and work the starter out. Sometimes the bolts are hard to get to.
the accelerator pump is the left side of the carberator or passenger side of the truck you see the link from the throttle cable hooked to it ,it has plunger shaped rubber on it an can be taken out by the two philps screws in about 10 minutes
Probable causes: loose cable or wire; faulty starter relay or solenoid.
how do replace an accellerator cable on a 1973 bug
The cable does not have any adjustment.
no