answersLogoWhite

0


Best Answer

If you're talking about that plastic box that holds the air filter - use Duct Tape.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can a cracked intake on a ford 4.6 engine be fixed with epoxy glue or anything else the crack is about 3 long and made out of plastic?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Intake plastic housing 96 crown vic police int?

What is the question? If you mean the plastic coolant cross over, then it must be cracked. You have to replace the intake with Ford's modified one.


Water in the oil of a Chevy 350 marine engine means what?

intake manifold gasket,head gasket,cracked head,cracked block. was it overheated? was cold water added to hot engine?


1999 silverado overheating coolant in oil is this most likely blown head gasket or cracked head?

Neither 1, It is a common problem with that engine for the intake gasket to leak engine coolant into the engine lifter gallery / into engine oil. Replace intake manifold gasket and change oil and FILTER a couple of times. A head gasket or cracked head will not allow engine coolant to get into the oil. If you got or over HEATED the engine like real hot then you may have blown are cracked a head but I doute it. Not common, Replace intake gasket and you'll see that the engine will be okay more then likely.


What damage would be done to a car if coil pack caught on fire?

The coil pack fire can damage anything close to the coil. Any wires could be damaged, and if the engine has a plastic intake, the intake could have melted.


What causes the presence of engine oil in the coolant tank or reservoir?

if there is oil in the coolant system it could be a crack in the intake, a ruined intake gasket, a cracked cylinder head


Where is the intake plenum located on a dodge charger?

It's directly underneath the plastic cover that covers the top of the engine, the plastic cover pulls off and the intake plenum is underneath it.


If your 1999 Ford Crown Victoria has an antifreeze leak at the rear of the engine what could it be?

check your heater hoses one connects to the intake on rear passanger side of the motor it is likely the intake cracked there is a recall on this issue if the intake has been replaced with factory intake it is possible that the intake gasket is leaking check the bolts to be tourqed to specs if gasket is leaking replace gasket Crown Victoria Plastic Intake Manifold Heater Leak Fix When the stupidly designed intake manifold cracks where the heater pipe sticks into the plastic here's how to fix it. You will notice the plastic around the heater pipe is connected to some plastic to the front of the car from it. Take a hacksaw blade and cut about a 1/2" groove in that plastic - just enough to get a hose clamp around the plastic circle that holds the pipe. Tighten the clamp and voila! No more leak.


What are tesigns of cracked intake gasket on a 3.8 engne 2000 Chevy Impala?

Engine coolant leaking internally and/or externally.


Will a cracked maifold make a 2001 kia sportage engine run hot?

if it is the intake manifold YES, exhaust manifold NO.


What causes excessive oil to go into the intake manifold in a turbocharged diesel engine?

your intake manifold gasket is cracked...replace it and you should be fine...if it continues you may have a bigger problem


Where is the Throttle body on 94 camaro 3.4?

It is between the black intake tube (plastic) and the intake manifold (aluminum part on top of the engine)


Where is the throttle body on a 91 accord?

it should be rite between the plastic intake tube and the intake manifold at the top of the engine. there is a hook where you can rev the engine without stepping on the pedal inside