yes its a timing belt if its the 2.0 L fs engine
IF ITS A 1.8, THEN ITS NEXT TO THE TIMING COVER
No , the 1.8 liter 4 cylinder in a 1999 Mazda Protege is not an interference engine
Hoo I set the correct timing on a 1993 mazda protege
The timing belt is located inside the timing belt cover at the fron of the engine.
it must be changed every 105,000 miles. Warning: This is an interference engine.
does a 1997 1.5l maxda protege have a timing belt or timing chain. When should i change it.
The timing belt for a 1996 Honda is on the front of the engine. It is located behind the timing cover.
A 2000 Mazda Protege with 1.8 DOHC engine appears to be a "free-running" engine, meaning there is no valve/piston interference in case the timing belt broke. There is enough clearance between the valve and piston, even if the cam stops (i.e. the timing belt breaks) with the valve fully open. Therefore, the car will not be damaged if the timing belt broke.
It has a timing belt, not a chain. The belt is located under the plastic covers on the passenger side of the engine.It has a timing belt, not a chain. The belt is located under the plastic covers on the passenger side of the engine.
On the 2.4L it is located under the plastic housing on the front of the engine. The 3.7L has a timing chain, not a belt.On the 2.4L it is located under the plastic housing on the front of the engine. The 3.7L has a timing chain, not a belt.
Every 90,000 miles per Mazda
The timing mark on a Chevy Inline 6 engine is located on the flywheel. It is a steel ball. The timing needs to?æbe located at 4 degrees BTDC.
Every 60,000 miles in a 93 Mazda Protege
The timing chain is inside the passenger side of the engine.The timing chain is inside the passenger side of the engine.
were are the timing marks located in 307 engine
Both the 1.6 Liter and the 2.0 Liter have a timing belt that must be replaced every 105,000 miles. The 1.6 L is not an interference engine but the 2.0 L is an interference engine.
The timing belt is located behind the timing cover on the front of the engine as you are looking at it from the passenger side front fender. The serpentine belt has to come off to get to it.
Ignition timing: Hook up a timing light to the #1 spark plug wire and battery, Loosen the bolts on the distributor. With the engine running shine the light on the plastic timing mark located on the lower timing belt cover. Adjust the distributor forward or backwards as needed to align the mark on the crank pulley with the big mark on the graduated pointer on the timing belt cover. Once aligned tighten the distributor and your done.
pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.
On a 2003 Mazda Protege it must be changed at 105,000 miles. This is an interference engine and as such if the belt breaks serious engine damage will occur.
It is under the timing cover and driven by the timing belt. Anytime you change one it is best to replace both as far as cost is the same.
There is no Timing Belt. It has a Timing Chain ,, inside the Engine.