Auto Parts and Repairs
Power Steering
Chevy Venture
Mercury Topaz

Can the power steering pump line be removed and replaced on a 93 Mercury Topaz?

545556

Top Answer
User Avatar
Wiki User
2015-07-15 20:49:33
2015-07-15 20:49:33

Yes! nothing special to look out for just do it. Underhood space is only problem really. May need special tool also.

anything can be replaced. however, which pwr strng line are you reffering to? the pressure line, the metal one, is a pain in the ***! it took my friend 4 hrs to do, and it winds dwon, around and up halfway through your motor to connect on the other side to your steering at the firewall. the part is very cheap, but labor is atrocious. my quote was $250 just in labor. i believe you can find the *how to* in a car manual. you do not have to buy at the store, you can go to the local library and find one, well, you should be able to. and copy the pages from the book so not to get grease on the book. my friend was able to do it with my manual. i more than the nike commercial above.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Mercury Topaz was created in 1983.

User Avatar

Activating your four-way flashers on a 1989 Mercury Topaz is very easy. All you have to do is reach under your steering wheel and pull the only handle down there.

User Avatar

i have an 87 topaz where the alternator goes bad also. have replaced it twice. it is just a common problem in the topaz's

User Avatar

Just take the covers off the steering column, switch is there.

User Avatar

It's under the steering wheel, left of the steering column. You gotta climb under the dash to see it, and look up.

User Avatar

how do you replace a power steering pump on 1992 mercury topaz

User Avatar

picture of the fan relay for 1993 mercury topaz

User Avatar

The 1994 Mercury Topaz has a chain and not a belt.

User Avatar

alternator-,ac pump-,steering pump-,crank pully-, idler pulley-,water pump

User Avatar

picture on how to replace a water pump for mercury topaz

User Avatar

A 1991 mercury topaz has drum brakes on the rear wheels.

User Avatar

does some one know the fireing block numbers for a 1994 mercury topaz 4

User Avatar

there are 5 wires that go to the starter relay on a 1993 mercury topaz

User Avatar

I also need to know how to install a alternator in a Mercury Topaz, but my car is a 1991. PLEASE HELP...

User Avatar

how to set timing on 92 ford mercury topaz 2.3 engine

User Avatar

Depends whats wrong. Is there oil in the pump? Does the pump need to be replaced? If so, just remove the belt and change the pump.

User Avatar

The wheel bearings for the Mercury Topaz are found on each axle. The average cost for a set of bearings is about 70 dollars.

User Avatar

In the glove box of my topaz "1993", there is a list of the fuses. Also the fuses are under the steering wheel. YOu have to get down on the ground with the door open and poke your head in sideways and look up at them. I hope I helped.

User Avatar

I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection

User Avatar

The fuse block should be located to the left of the steering column, under the dash. Depending on which Mercury GS you have (sable, topaz, etc.) it should be a relay located in the fuse block.

User Avatar

Since you had to unplug the wire connector, there is most likely damage to the connector. Check it carefully.

User Avatar

Your 1991 Mercury Topaz 2.3 liter has a timing CHAIN


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.