put it in 4x4, and it does it for you. or install locking hubs for 50 bucks.
A 1988 Ford Bronco weighs between 4300 and 4600 lbs. Weight variations depend on the make of the car and if it has been modified.
The only size I can find is for a 1988 Ford Bronco II Eddie Bauer: 205 75 15.
yes you may have to inter change a few things but they will fit
There is no 1988 Ford Explorer. The vehicle went into production in 1990 for the 1991 model year, replacing the two door Bronco II;. As for the Bronco II, there isn't an OBD port.
where is fuel shut off switch for Ford Bronco eddy Bauer
The easiest way to fix a 1988 Ford Bronco gas hose leak is to replace the hose. You can also patch the week in the hose.
According to www . ford parts . com ( no spaces ) For a 1988 Ford Bronco , 302 cubic inch V8 engine The spark plug gap is ( .044 inch )
Where can I find a free starter solenoid replacement diagram for 1988 ford f250
I have a 1988 ford bronco 2 with a 2.9 six cylinder with 103,000 miles and still get 22 mpg on the highway.
try to disconnect battery for 30 seconds
Approx. 3000lbs or 1.5 tons
Motorcraft ( CM 4764 ) according to motorcraft . com ( no spaces ) new fuel pressure regulator for a 1988 Ford Bronco 351 cubic inch
I BELIEVE the 2.9 liter V6 engine in a 1988 Ford Bronco II is rated at ( 140 horsepower from the factory )
Amazon and eBay. But if you are a serious off-roader manual hubs are better
Probably not because the Ford Bronco and Ford Bronco 2 were not very good by their motor.
No there isn't. The Ford Bronco and Ford Bronco II have not sold very well and The Ford Motor Company is not interested on making a Ford Bronco III because of this situation.
go to autozone.com, they have free pics
10 degrees BTDC with Spout disconnected.