answersLogoWhite

0


Best Answer
Copy

You need to get into "THe Zone" and buy the repair book for F*** trucks. LOl Best $13.00 you will spend.

Don't pull the motor. Take out the transmission, front drive shaft and transfer-case. This will take you about 12 hours.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:42:02
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Can you change the rear main seal of a 1988 F150 4.9L by dropping the trans instead of pulling the motor and do you need any special tools?
Write your answer...
Submit

Related Questions

Where is the fuel filter located on a 2002 Ford Ranger 4x2?

Check under the truck about in line with the seat . You may need special tools to change it. the fuel pump for a 2002 ranger is located in the gas tank. pulling the bed off is easier than dropping the tank for this repair


A change in the force of gravity pulling on you will change your what?

It will change your weight.


A change in the force of gravity pulling on you will change your?

Weight


Is dropping a potassium in a water a physical change?

yes it is a physical change !


When did dropping the golf ball change from over your shoulder to in front?

1954


Do leaves ever change colors?

Leaves on deciduous trees change colour in the Autumn prior to dropping.


How do you change the harmonic balancer on a 2003 Chevrolet Impala and where is it located?

It requires a special puller and it is located on the front of the engine. It will require pulling the radiator and fan. You will need an air wrench to remove the bolt.


What ways can a machine change a force to push or pull?

It can change by moving pushing or pulling you force it to


Can you change the fuel pump without dropping the tank on a 88 mustang gt?

NO


Is dropping a penny into a class of water a physical or chemical change?

physical! STUPID


Is dropping bread a chemical change?

No because it is not changing the chemical structure of the bread


How can you change the transmission fluid in F100 without dropping the pan?

You could remove the transmission and pour it out of the rear driveshaft seal. But I would recommend dropping the pan.


Is a plate is dropped and shattered a chemical change?

A plate dropping and shattering is a physical change. It is not a chemical change, as the material used in making the plate doesn't change.


How do you change fuse in fuse housing for air conditioning?

Usually just by pulling them out with a special pair of plastic pliers called fuse pullers. It would be recommended to find the cause of the blown fuse first.


What are change-ads?

Change-ads are advertising envelopes used to prevent dropping change in the restaurant drive-thru lane. Change-Ad Media Group


Is pulling copper into a thin wire is a physical or chemical change?

physical


How does tension change the earth's crust?

by pulling it making it thinner in the middle


Is dropping a Tums in water a chemical change?

yes it is because it creates a new substance.


How do you change c v joints 1989 topaz?

do not remove strut bolts instead take lower balljoint loose ,take axle nut loose pulling spindle out as you push in on axle, then pry axle out of trans


What should I change to make my haiku the right number of syllables pushing and ย pullingย  the sea is very rough to me wave after waveย ?

Pushing and pulling The sea is so rough to me Wave after next wave


Special force change password?

how to change password in special forces 2


Can you change your freeze plugs without pulling the motor?

It is impossible to do it you have to pull the engine


How did dropping the atomic bomb change the atomic age?

Well, it was usually considered the official start.


Are clouds dropping rain chemical or physical change?

cb kjbskjv bakbvj bakb v


What are the uses of a single pulley?

AnswerA single pulley can change the direction of a pulling line. The direction change may help in pulling the line over a corner or around an obstacle. Or the direction change may allow better use of the available pulling force. Also, the single pulley can relocate the pulling point.For example, suppose we wish to lift a weight some distance into the air. If I am the pulling force, then my first problem is that I cannot lift the weight any higher than I can reach. But if the pulling line is looped over a pulley some distance above my head, relocating the pulling point, I can potentially lift the weight just about up to the pulley's height. And now the pulley has given me another advantage. I can leverage my own weight, pulling down on the line, to lift the weight upward.