Best Answer

Yes, It's an easy repair

Do a compression check also to verify the rings or piston for the noise

User Avatar

Wiki User

โˆ™ 2009-12-10 20:23:45
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Can you change the rodbearings and camshaft on a 1996 Saturn SC2 without having to replace the whole engine it is knocking a little?
Write your answer...
Still have questions?
magnify glass
Related questions

How do you replace the camshaft position sensor in a 98 Nissan Pathfinder 3.3L 2WD without buying a new distributor?

You can't, it's a non serviceable unit and you must replace the whole distributor.

What is the highest RV camshaft you can put in your Chevy 350 motor without having to replace the torque converter?

Contact the cam manufacturer of your choice for a specific recommendation.

What sneaks through doors and windows without knocking?

The sun?

Can you change camshaft without removing the engine?

that depends on what car you are working on

Would a 1997 3.3 Plymouth voyager van run without a camshaft?


What is the crossing in a church?

A place you can safely walk without overenthusiastic dancers knocking you over.

If your little brothers won't stop walking into your room without knocking how do you get them to stop?

start staying naked while you are in your room. they will probably start knocking after they walk in after a few times.

How do you win a showjumping round?

You win by- Going through the round first without knocking down rails then how ever many people make it "clear" they do a jump of round (witch is the same or a different) course as fast as they can without knocking down rails.

What does scopey mean?

Scopey means a horse jumps very clean over tall jumps.Very Scopey - Can jump lots of jumps, very tall, without knocking over poles.Not Scopey/Not very Scopey - Can not jump most jumps without knocking them over.

Where is a camshaft position senson on 1988 Pontiac Bonneville?

The Camshaft Sensor is located right behind the crank shaft fly wheel and can be very hard to change out without consulting a mechanic first.

What is the goal of high jump?

to go over a thirteen-foot-long raising bar without knocking it over.

What is the goal of the high jump?

to go over a thirteen-foot-long raising bar without knocking it over.

People also asked