I don't know what your definition of a small amount is but, I wouldn't leave it in there for long. Change the engine oil and filter as soon as possible with the correct oil for your car.
I have known some old timer mechanics who used to do that to help clear sludge from inside an engine.
the tranny dipstick is at rear of the engine on the drivers side of the car the tranny dipstick is at rear of the engine on the drivers side of the car the tranny dipstick is at rear of the engine on the drivers side of the car
The tranny ( or transaxle / transmission ) on a 1993 Mercury Tracer is in the engine compartment bolted to the engine on the drivers side of the engine
Yes it will it has the same two concertors on the tranny as the tiburon
powerglide is a tranny
Powerbrake the vehicle in drive and reverse and if you see them jump under hood, you may have a bad engine/tranny mount
Not for fitment issues but the WRX tranny is considerably weaker than the STi tranny and the extra power from the STi engine stands a good chance of causing a failure in the WRX tranny (especially the weak 2nd gear).
unhook everything on your engine and take your engine and tranny off the chassie. Then you remove the entire engine and tranny combo from your van. empty the transmission oil and undo the bolts connecting the transmission to the engine. The do it all in reverse and add new transmission fluid and whatever else fluid you had to empty to get your engine tranny combo out.
You just take all the bolts out of the tranny that holds it to the engine, take the tranny cooler lines off the tranny, unhook the shifter cable and unbolt the torque converter from the flywheel and your good to go.
there should be a thin guard usually stainless steel that fits over the guides for lining up the tranny. between engine and transmission.
With the car jacked up and level. Follow the right side axle inboard into the tranny. Where the axle enters the tranny you will find a 7/16 bolt at approximately the four oclock position. It is a small hole so look carefully. With the engine running and the tranny hot remove the bolt. If fluid does not drain at small portions of fluid until it seeps out. If adding fluid after a tranny filter change it will take about 7.5 quarts.
With the car jacked up and level. Follow the right side axle inboard into the tranny. Where the axle enters the tranny you will find a 7/16 bolt at approximately the four oclock position. It is a small hole so look carefully. With the engine running and the tranny hot remove the bolt. If fluid does not drain at small portions of fluid until it seeps out. If adding fluid after a tranny filter change it will take about 7.5 quarts.
w58 tranny