I once had this problem ask everybody, even dealerships . said they didn;t know or were to busy to give me the time of day ( that the problem with people nowa days. when I finally found my answer ,it was by error, and I felt dumber then my children act. here is what I found out when you buy a new belt ( I bought mine at autozone) look on the cover of that wraps the new belt, like I said I tried and tried for hours to get that belt right and something guided my to the cover and there they where all the diagrams for installing that belt on 4 different motors. my face was so red when the belt just slipped right on I felt like I needed to go back to 6 th grade shop all over again. hope this helps. and if it does don't feel stupid its a natural mistake anyone can make. if it doesn't e-mail me at firstname.lastname@example.org and I will e-mail you the diagram, ok.....
Mine is 20 gals. or I believe 79 liters.
Too the best of my knowledge, no. The 1991 used a sealed beam and the 1997 used a halogen type.
how do you fix a gas guage on a 1989 ford aerostar
picture of engine of 1991 ford aerostar van
On a Ford Aerostar 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
Sam place you check it.
yes it does!
Haynes makes a manual with the wiring schematic for the O2 sensor on a 1991 Chevy Blazer S10. The manual can be found at most book stores.
Antilock brake system
The price varies for a head gasket by location for a 1991 Ford Aerostar van. The approximate price for the head gasket if you are going to do all repairs yourself is approximately $80.00.
schematic on 1991 cadillac fleetwood air condition
You can find wiring schematic @www.modifiedlife.com falconspath
Yes, both the 3.0 and the 4.0 are fuel injected.
There is a cdoe programed in to the vans "brain" and it is telling you that there is something wrong. i have fixed this in a 1994 Aerostar. The dealer will know what to do from there.
You can find a wiring schematic for the fuel pump circuit open wiring on a 1991 Town Car in do-it-yourself repair manuals. Haynes makes one of the most popular manuals.
Does it turn over? Does it have spark? Fuel?
as far as i know it on the vac by the firewall left side
The correct gap is .044
SAE 10W30 any major brand.
Look near or behind the alternator. The valve that controls flow of coolant to the heater core on my 1987 Aerostar is located on the left wall of the engine compartment. I imagine the 1991 is similar. Trace the heater hoses from the engine/water pump and you will find it.
Mazdatruckin.com has a schematic for the B2600i vacuum lines in their tech section, it includes 4wd and cruise control devices. See the attached links below.
Follow the posative cable from the relay to under the car and the starter is at the end.