Yes, you can y cord the inputs of amps but not the outputs.
They're both the same. A "channel" stereo receiver merely accepts a given number of channels (2,4,5, &tc.). A stereo receiver has 2 channels of audio output, left and right. A receiver marked as ___ channel receiver has the corresponding number of channels. For instance a 5 channel stereo receiver can play 5 different channels of audio through 5 speakers. If the receiver has a decimal, such as 5.1 or 7.1, that indicates that it has 5 or 7 channels of regular audio, plus 1 channel for subwoofer, making them 6 and 8 channels, respectively.
A 7.2 surround receiver is used for viewing movies encoded with 7.1 channel surround sound. Very few movies have this many channels, so most of the time it will be doing 5.1 surround. The .2 part indicates the receiver has 2 subwoofer outputs, however, they are the same channel information.
You may not have your Dish satellite receiver on the correct channel if it is a duo (dual receiver). You will need to tune it to either 60 or channel 73. Also, make sure your power to your Dish Network receiver is on -- for the Dish TV duo receiver, you should see a light for TV2 and TV1.
If the receiver is just stereo, not surround sound, you will not be able to create a surround sound (front, centre, sub, surround) setup.
atn bangla
Up to 4 WaveBird controllers can be used on a single receiver. Each controller will have its own channel to communicate with the receiver, allowing for multiple controllers to be used simultaneously.
Yamaha's present equivalent to the RX 500 U receiver is the RX-V367BL. This receiver is iPod and Bluetooth compatible and has 5 channel surround sound.
It will if your surround receiver is configured with the front or center channel speaker as 'small'. If your front speakers are tower-type, then the receiver should be configured with the speaker size set to large. This will allow the subwoofer to reproduce only the LFE channel. If you notice the volume jumps when the frequency of the sound lowers, you probably have your sub turned up too much. Try running a THX sound setup demo that is featured on many different movies.
At the rear of the receiver there is a single RCA jack (phono socket) that is marked "audio out" and "sub-woofer". This is a mono feed that can be connected to a powered sub bass unit. It will not drive an un-powered bass speaker that does not have an internal amplifier. If the bass speaker is not powered, the audio out from the receiver can be taken to a single channel of another amplifier and the bass speaker then connected to the speaker output of the amplifier.
The dish on the outside of the house picks up the signal beamed down from the satellite in space. From the dish the signal is sent to the receiver. The receiver decodes the signal to provide the channels you subscribe to. If you aren't subscribing to a certain channel, a message will tell you so and that you can upgrade to the package with that channel.
Message, Sender, Channel, Receiver, & Feedback.
- Sender : the person who send the massage- Message : the massage that send from the sender- Channel : the transmission line connect between sender and receiver- Receiver : the person who receive the massage through the channel