no you cant the bolt patern on the vtec heads are different then the non vtec heads
No. The cylinder head on the Type R and GSR are different. The bolt and coolant holes will not match up. However, the Type R's intake manifold will fit a 99-00 Civic SI because their cylinder heads are similar.
nop
You need to bolt the Civic seat rails to the Integra seats I believe. But yup, I got GSR seats in my CX. bolt them up
getting the engine worked on and put in a cold air intake
put new gasket on the intake manifold and bolt carb down to intake manifold and hook up all linkages and hoses.
Remove the intake manifold retaining bolts from your 1993 Mercedes-Benz manifold. Remove the old manifold gasket. Clean the surface and put the new gasket on.
No.
i dont see why not, if your installing oem or an aftermarket a/intake it still needs of it i put an Injen a/intake and engine breaths better and cleaner not to mention more power
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
you take the intake out and put it by the manifold
I had the same question when I put a head gasket on my 89 LX. The head has to come off in order to remove the intake manifold. There is no other way around this.
Change the intake manifold and fuel pump... And naturally put a carb on top of the new intake.