Jeep Wrangler
Jeep Wrangler Sport
Chevy 350

Can you put a Chevy 350 in a jeep?

373839

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 15:50:25
2011-09-12 15:50:25

I have a Chevy 350 from a 1985 blazer in my 1990 wrangler. So yes it is. I also have the transmission and transfer case from it in my jeep to.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


With enough money anything is possible even though Chevy 350 is a small block.With enough money anything is possible even though Chevy 350 is a small block.

Chevy did not make the Wrangler, Jeep (Chrysler) did, and they did not come with a 350 - that's a GM engine.

As far as a direct bolt in engine swop NO NOT EVEN CLOSE.iF YOU know WHAT YOU ARE DOING YOU CAN PUT A 350 IN ANYTHING.

wat other motor can i put in my 2001 chevy blazer

the block & heads are the same you just have to pull the 305 out & put the 350 back in

It can be made to fit, but in no way is a direct drop in.

The 1972 Chevy 350 has about 270 horsepower stock. This engine can be modified to put out up to about 800 horsepower.

AMC 304, Chevy 350, Ford 302, get the point.You will need to do alot of new wiring and a conversion plate to bolt up the tranny.Good Luck! EJEEPERGUY

Many Chevy motors will interchange, need to know what you have in mind.

YES, If you know what your doing.

An olds 350 engine such as one that they put in the 1979 toronados. Don't think you could put a Chevy 350 in without major mods.

The 305 was an option on that car, so a 350 should be a bolt-in.

yeah, but it might blow a head gasket, i wouldn't chance it

The 350 Rocket from the olds is Far superior. I just put one in my Grand Prix switched from the 350 Chevy and with a 4 barrel holly carb you will notice a BIG difference.

undo the wires then take the bolts out then put the new one in.

Yes it will bolt right up with no problems.

You can make it fit with plenty of money and fabrication but it is not a plug and play.

Anything is possible, but that would not be easy. You would need a transmission, transfer case, and drive shafts that matches up to the Chevy. You would also need to adapt everything under the hood from a Jeep to fit a Chevy motor.

A stock 350 CID Chevy will put out anywhere from 150 hp to about 300 hp, depending on when it was made. Or if it is fuel injected the power ratings may be higher.

the heads should fit as long as your not trying to put them on a big block

Should bolt right up... that motor didn't change for 40 years.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.