0
Can you remove the oil pan on a 96 Cavilier z-24 without pulling the engine?
Wiki User
∙ 14y ago
Yes
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you remove the engine 1995 wrangler 2.5 liter without pulling 5 speed transmission?
Yes, the engine will pull right out without removing the trans.
Can 95 Chevy freeze plugs be replaced without removing engine?
You can replace all of them BUT the 2 in the rear of the engine block with out pulling the engine. To remove the rear ones you can either pull the transmission are remove the engine your choice.
Can rod bearings be replaced without pulling motor 1994 Toyota 4WD 6 cyliner?
Yes, you do not have to remove the engine.
Can you remove both heads from a 1998 Chevy Lumina without pulling entire engine?
Yes, it's tight but do-able.
Can you replace the rod bearings in a 1999 Pontiac grand am without pulling the engine?
Yes..you should be able to. You'll have to take off the starter, remove the front engine mount to be able to lift the engine slightly then remove the oil pan.
Can you remove a Grand Marquis oil pan without pulling the engine?
Yes, it is possible. But buy a repair book first as it is very difficult!
How do you remove gearshift knob from 1999 Chevy cavilier?
you have to twist it off.
Cadillac Brougham 1988 Oil pan leaks needs a new gasket which comes in two parts Can I remove the oil pan without pulling the engine?
You can't. The engine has to be lifted to get to the oil pan.
Can you drop the pan on a 1991 Ford Explorer without pulling the engine or axle?
take the motor mount bolts loss and lift the motor.you should be able to remove it
Can an automatic transmission be removed from 95 GEO without pulling the 1.3L engine?
yes, remove the driver side tire, then unbolt the tranny from the morot and pull it out the bottom. (best way without taking the motor out.)
How do you replace the alternator on a 1999 Chevrolet Cavilier?
disconnect battery. remove the belt, remove the plug in the back, remove the bolts holding it on. then reverse procedure.
How do you replace the oil pan gasket on 1989 camaro RS with a 305 V?
Without pulling the motor completely out, remove mount bolts, loosen y-pipe, remove starter, lift engine with a hoist and work from there..and trust me USE RTV SILICONE!!
