If you are refering to the 4.0 liter s.o.h.c.,which I think you are. It does not have (tappets) lifters. Its a single overhead cam engine.(no pushrods or lifters)The values are opened directly by the cam.
no have 2 remove tank
You can change internet explorer 7 to the last veriosn of the internet explorer , by removing or Uninstalling the Internet explorer 7 from the add and remove . this will help in removing the internet explorer 7 from computer
Yes, to access the tappets(lifters) you have to remove the cylinder head.
The car has only one transaxle, AKA transmission, then no, you cannot remove the tranny without removing the tranny. If you mean without removing CV Axle or drive axle or Axle shaft or CV shaft (same thing) then the answer is still no. You cannot remove the transaxle without removing the drive axle/CV shaft.
that is probably an oil pressure switch that you see. coolant temp sensor is usually near the thermostat in the manifold.
You can remove the 2005 Ford Explorer rear wiper arm by removing the retaining clip. The retaining clip is just below the wiper arm connection.
According to my Haynes Ford Explorer repair manual : On the 4.0 liter OHV / pushrod style engine , in order to remove the timing chain cover you have to remove the oil pan which involves removing the engine
having trouble removing the transmission oil pan from a 1998 explorer sport 4x4. need photos.
yes you can remove the fan clutch without removing the rad. it is tight but it can be done. it is easier with the Rad removed
by removing it with cutting plyer without bending them or twisting them with a hammer
You must remove the wheel/tire in order to remove the front strut.
No just the rocket cover