answersLogoWhite

0

Can you reset the GM Passkey II?

Updated: 9/11/2023
User Avatar

Wiki User

14y ago

Best Answer
Answer no you can't, your car is dead and the starter is locked out....probably due to a blown fuse ie (horn) Answerno you can't, your car is dead and the starter is locked out....probably due to a blown fuse ie (horn)
User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you reset the GM Passkey II?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there a fuel pump reset on 1997 V6 camaro?

No, GM does not use inertia/reset switches.No, GM does not use inertia/reset switches.


What wire on the fuel pump relay is the reset on a 1988 grand am?

GM vehicles do not have reset switches.GM vehicles do not have reset switches.


What is the passkey to pair plantronics explorer 2xx with ps3?

0000 almost all are 0000, but you can reset most


Is there a fuel system shutoff reset 2005 grand am?

GM vehicles do not have inertia/reset switches.GM vehicles do not have inertia/reset switches.


Can you reset passkey II on a GM truck?

Passkey II can be reset based on the type of Truck you are looking at. You can usually reset it by the steps below. To determine if the passkey is your problem you need to know if the security light is flashing, solid, or out. Observe the Security indicator lamp in the instrument panel. Remove the key from the lock cylinder. - Security indicator should be Flashing when the door is open. - Security indicator should be Off when all the doors are closed. - If the Security indicator does not come On or go Off correctly, refer to the Content Theft Deterrent System diagnostic and repair information in the applicable Service Manual. With the Doors closed, place the key in the lock cylinder and turn to the Run position. Observe the Security indicator lamp. - Lamp is On and does not go Off however, the engine starts. This indicates that the Vehicle Theft Deterrent (Passlock) system detected a fault when the engine was running. - Lamp flashes On and Off. This indicates a problem has been detected by the Passlock(Passlock™) system and the engine may not start this key cycle, a current condition. If you determine that the Passlock is the issue, you need to do some web research on the "corrosion of the passlock system" GM had massive issueswith them and you may be able to get the answer there.


Where is reset for fuel pump located 1998 s-10 truck?

It doesn't have a reset. GM vehicles do not use inertia switches.It doesn't have a reset. GM vehicles do not use inertia switches.


Where is the fuel pump reset switch on a 1988 IROC?

GM vehicles do not use inertia/reset switches.GM vehicles do not use inertia/reset switches.


How do you reset passkey II on 1999 cadillac sedan deville?

u dont u probably need a new one u have to go to the dilership its gona cost u under $50 dollars and they will tell u how to reset the new one because it works with radio waves and urs is probably bad already


Where is emergency fuel shutoff switch on a 93 Pontiac transport?

Gm vehicle do not have inertia/reset switches.Gm vehicle do not have inertia/reset switches.


Where are the resets for the fuel pump on a 94 park avenue ultra?

GM vehicles do not use reset buttons.GM vehicles do not use reset buttons.


Where is the reset switch for a 2000 Chevy express1500 van 4.3 engine v6 gas pump?

GM does not use inertia/reset switches.GM does not use inertia/reset switches.


Where is the fuel safety shut off switch in a 95 GMC jimmy?

GM vehicles do not have inertia/reset switches.GM vehicles do not have inertia/reset switches.