You can change a head gasket if that is all that is wrong.
Take it off, replace the gasket
The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.
Take it to a mechanic nobody can tell you how to replace a head gasket over answers.com it requires someone who knows how to rebuild engines when a head gasket blows it requires the engine to be disassembled and rebuilt.
No. You can have the head gasket replaced. This is unless you kept driving the car with a blown head gasket and have totally destroyed the engine.
In short you have to take the head off, replace the gasket/s and replace the head. You best bring it to a pro.
sway bar must be disconnected so you can move it out of the way
JUST HAD BBOTH DONE IT COST $1336.OO
Remove upper and lower engine intakes. Tie back or label tubes so not to loose reconnections. Once everything is remove the gasket is exposed. Pull gasket replace, then return intakes and labeled tubes.
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
The four cylinder Fiero engine has a bad problem with cracking the cylinder head. If the gasket is bad it is likely the head will need an expensive repair. If the car has the V6 engine it is possible to just replace the gasket The real question is how good was the engine before the gasket failed? Should it be rebuilt or was it not burning oil and in good condition before the failure. Did the gasket failure cause any damage to the engine?
A blown head gasket is :either the problem ora victim.a victim of warped head, block or bad weak head bolts.the cost correcting the above can vary.CHEAP IF JUST THE GASKET. EXPENSE IF YOU NEED A $300 REBUILT HEAD.FIGURE 6 HOURS LABOR JUST TO REPLACE GASKET + PARTS AND REBUILT HEAD.The head gasket is between the head and the block the head must be rmoved to replace it. if the head is cracked or the engine was overheated more serious problems will result. it is a rather costly job to have done around 600 to 800
Depending on the engine ball park $700.00 to $1500.00 or higher if the heads are warped etc. There are two heads, never replace just one gasket.