call a wrecking yard, or better yet stop by and speak to one, over the phone they don't like being bothered...
It should be the same exact thing
In the cap on the front pass side of the engine.
For a 2003 Chevy Suburban (all engine sizes), the recommended viscosity is 5W30.
yes you can but you might have to change your intake.
You take one engine out of a car and put another one in. Done.
Take the battery cable off for five seconds, and put it back on.
1 take out the engine 2 put a new one in duhhhhhhhhhh
I have a 95 Sonoma. I use 5W30.
According to the 2003 Ford Expedition Owner Guide : With engine oil filter change : The 4.6 and 5.4 liter V8 engines take : ( 5.7 liters / 6.0 U.S. quarts of 5W-20 )
2003 CHEVROLET CAVALIER 2.2L 4-cyl EngineCAPACITIESEngine, with Wix # 57082 Filter..........5.1 quartsHope This Helps.
According to the 2003 Ford Crown Victoria Owner Guide : With engine oil filter change : ( 5.7 litres / 6.0 U.S. quarts of engine oil )
Don't. An Rx-7 is a perfectly balanced car with its lightweight, smooth accelerating rotary engine. If you take good care of it, it will take good care of you. If you want to put in a different engine in it, a corvette engine is the only way to go.
the amount of oil that your suppose to put in is 5 quarts
it depends, do you wanna swap with a V6 or just and I-4
it should take about 4 and a half
Take out the 7M and put a JZ engine in it. www.driftmotion.com
Take it out and put a new one in.
Depends on which engine and how much work you are willing to do.
Take it out and put a new one in!
If you have enough money and skill you can put about any engine in any car.
every website that i have seen says that 5.3 liter v8 engines for 2003 models for Chevy trucks and SUVs put out 285 to 295 hp
The easiest way to reset the check engine light on a 2003 Jaguar XJ, is to remove the fuse. Keep the fuse out for 10 seconds and then put it back in. If the engine light remains on you should see a mechanic.
put your key in the ignition and turn it and hold it till it stops cranking. k.