The 3140 was created as a direct replacement for the 741, not really the other way around. That being said...
Most of the time, I'd say yes. However the 3140 has a higher input impedance than the 741, so there is the chance you could drag down whatever is driving the inputs.
The CA3130A offers superior input characteristics over those of the CA3130. or combine both CMOS and bipolar transistors independently by considering proper limitations;it may work
In Ic 741, 7 represents active terminals,4 represents inputs and 1 represents the output
The basic function of IC 741 is amplification. It is mainly used to magnify amplify weak signals inside a circuit.
A 741 Op-amp has three distinct parts and applications. They are a differential amplifier, a voltage amplifier, and an output amplifier.
power supplies +5v and -5v will be given to 7 and 4 pins respectively,therefore it is used for giving power suppply to ic 741
pin1to 8 is used in ic741
The CA3130A offers superior input characteristics over those of the CA3130. or combine both CMOS and bipolar transistors independently by considering proper limitations;it may work
In Ic 741, 7 represents active terminals,4 represents inputs and 1 represents the output
my foot
no, the 741 opamp is a monolithic IC.
A: You can find all information at datasheetlocator.com I hing this is a RCA part.
Nothing. It's labeled NC - No Connection
operational amplifier
The basic function of IC 741 is amplification. It is mainly used to magnify amplify weak signals inside a circuit.
ic 741
It is an opamp chip consisting of 8 pins
The 3130 is an all MOS design whereas the 3140 is MOS input and bipolar output giving it a much better output drive. The 3140 is preferred in most applications.