You would need a ring gear for an automatic.
You have to use the flywheel for the 1974 engine and the clutch plate for the Trans Am.
no unless so one make a kit to do that tranadap.com 400 trans is longer than 350trans best to rebuild 350 trans i can rebuild for 500.00 you will have better trans then bsnward@yahoo.com
turbo 350 or 700r4 turbo 350 or 700r4
yes it is a 350 turbo trans is always just that a turbo 350, almost all Chevy parts are interchangeable, it is the same transmission and chances are they both have the same engine most v8 gm be it car or truck use similar drive train unless its 4x4 than it wont work in a car
80w90 gear oil works fine. so need for synthetic in your case.
A small flywheel needs to stay with the starter that goes to it. You can use either flywheel, and the block should be drilled for either starter.
Probably not. It will likely be too short.
No
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
"Turbo 350" is a slang expression for General Motor's Turbohydramatic 350 automatic transmission. It is a 3-speed fully automatic transmission originally intended for use with engines that produced up to approximately 350 pound-feet of torque.
a 700r4 trans out of a s10 with a 4.3 will bolt up to a 305 but you will have to use flywheel cover for the s10 trans.
That is normal, Just put the converter bolts in it and it will be alright.