Clutches and Flywheels
Jeep Wrangler

Change a clutch on a 1993 jeep wrangler 4.0?


Top Answer
User Avatar
Wiki User
2008-12-05 12:31:19
2008-12-05 12:31:19

How to change a clutch and master cylinder on a 93 Jeep wrangler

User Avatar

Related Questions

A 1993 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.

Your clutch is not working any more, check,

How do you replace the clutch slave cylinder on a 1989 jeep wrangler

A 2002 Wrangler has a non adjustable hydraulic clutch.

all clutches are internal. that is to say they are inside the bell housing

its in the cab right next to your left foot if it was on the clutch...

the same as any other clutch.

how to replace the slave cylinder on a 1993 jeep wrangler

you cannot adjust you need new clutch.

This should have a hydraulic clutch and would not be adjustable

No.The clutch is hydraulic and not adjustable.

The correct factory tire size for a 1993 Jeep Wrangler is 215/75R15.

How do you change the steering shaft in a 1990 Jeep Wrangler?

You dont it adjusts its self. if its slipping you nead a clutch.

With just that to go on I would say that your clutch release bearing is going bad especially if the noise quits when you put pressure on the clutch

how to change the windshield wiper motor in a 2000 jeep wrangler

The windshield streaming after a radiator change on a 1993 Jeep Wrangler is a result of a loose connection. Steam is caused when coolant leaks onto the engine and is heated rapidly.

no it will not, the frame is slightly smaller in the earlier jeeps

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

The gas tank on a 1993 Jeep Wrangler is under the very rear of the vehicle. It is just in front of the rear bumper.

You dont. It is hydraulic. Cannot be adjusted.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.